Advertisement
Before drilling holes in ANY part of a vehicle, be
sure that both sides of the mounting surface are
clear of parts that could be damaged: such as brake
lines, fuel lines, electrical wiring or other vital
parts.
3. Use the assembled unit as a template, adjust as
necessary, and scribe mounting hole position marks on the
mounting surface.
4. Drill mounting holes at the previously scribed
position marks.
5. If required, locate and drill an appropriate hole for
routing the 13-conductor cable and connector to the Lamp
&Relay/Interface unit.
E.
ELECTRICAL SPECIFICATIONS.
This unit is intended to operate on a 12.8 VDC, nega-
tive ground system. This unit is designed to operate in
conjunction with Federal Signal SignalMaster controllers
330102, 330103, 331102, and SmartSiren® models with
SignalMaster control.
F.
TESTING.
This product contains high output LED
devices. To prevent eye damage, do not stare
into the light beam at close range.
After installation is complete, check the entire system
for proper operation and ensure that all siren/light system
functions are operating properly.
1/4-20 KEPS NUTS
1/4" EXTERNAL
TOOTH
LOCKWASHERS
1/4-20 x 7/16" HEX
HEAD SCREWS
EXTENSION BRACKET
5/8" TYPE B HEX
HEAD SCREWS
SWIVEL
BRACKET
1/4" EXTERNAL TOOTH
LOCKWASHERS
1/4-20 x 7/16" HEX
HEAD SCREWS
MOUNTING BRACKET
W/PEM ASSEMBLY
Figure 1.
The lives of people depend on your safe
operation of Federal Signal Products. It is
important to read and follow all instructions
shipped with the products. In addition, listed
below are some other important safety in-
structions and precautions you should follow:
•
Although your warning system is operat-
ing properly, it may not be completely effec-
tive. People may not see or heed your warn-
ing signal. You must recognize this fact and
continue driving cautiously.
•
Also, situations may occur which obstruct
your warning signal when natural or man-
made objects are between your vehicle and
others, such as: raising your hood or trunk
lid. If these situations occur, be especially
careful.
•
This product contains high intensity LED
devices. To prevent eye damage, DO NOT
stare into the light beam at close range.
•
At the start of your shift, you should
ensure that the light is securely attached and
operating properly.
RETAIN AND REFER TO THIS MESSAGE
G. MAINTENANCE.
1. General.
Crazing (cracking) of lenses will cause
reduced effectiveness of the light. Do not
use cleaning agents (which will cause craz-
ing) such as strong detergents, solvents, or
petroleum products. If crazing of lenses does
occur, reliability of light for emergency sig-
naling purposes may be reduced until lenses
are replaced.
Ordinary cleaning of the plastic lenses can be ac-
complished by using mild soap and a soft rag. Should fine
scratches or a haze appear on a lens, they can ordinarily be
removed with a non-abrasive, high quality, one-step, auto-
motive paste cleaner/wax and a soft cloth.
2. Replacement Parts.
The unit must not be opened under any circum-
stance. Failure to adhere to this may result in moisture
entering the unit causing premature failure. Please contact
the factory if the unit is not functioning properly.
Manufactured by:
Federal Signal Corporation
Emergency Products Group
2645 Federal Signal Drive
University Park, Illinois 60466
1-800-433-9132
Email: empserviceinfo@fedsig.com
290A5601
Copyright 2006 Federal Signal Corporation
-2-
SAFETY MESSAGE TO OPERATORS
Advertisement
