Related Manuals for Federal Signal Corporation SIFMH
Summary of Contents for Federal Signal Corporation SIFMH
- Page 1 Models SIFMH, SIFMR (Discrete) and Models SIFMJH,SIFMJR FSJoin (Serial) ™ Rear ILS Light Bar Installation, Maintenance, and Service Manual 25500676 Rev. A0 1020 Printed in U.S.A. © Copyright 2020 Federal Signal Corporation...
- Page 2 This product is subject to and covered by a limited warranty, a copy of which can be found at www.fedsig.com/SSG-Warranty. A copy of this limited warranty can also be obtained by written request to Federal Signal Corporation, 2645 Federal Signal Drive, University Park, IL 60484, email to info@fedsig.com or call +1 708- 534-3400.
-
Page 3: Table Of Contents
Figure 1 DIP switch locations the control boards of the serial controlled ILS ......10 Figure 2 Discrete-wire control cable....................11 Figure 3 Exploded view of SIFMH ILS (vehicle-specific) ..............16 Figure 4 Rear SIFM shroud assembly ....................18 Figure 5 Exploded view of Rear SIFM....................19 Installation, Maintenance, and Service Manual Federal Signal www.fedsig.com... - Page 4 Table 3 Description of SIFM SpectraLux ILS control wires ............12 Table 4 Discrete-Wire SIFM light bar controls ................. 12 Table 5 Replacement parts for Rear SIFM light bar (Figures 4 and 5) ........... 18 SIFMH, SIFMR (Discrete) and SIFMJH,SIFMJR FSJoin ™ (Serial) Rear ILS Light Bar Federal Signal www.fedsig.com...
-
Page 5: Safety Message To Installers And Service Personnel
Safety Message to Installers and Service Personnel Safety Message to Installers and Service Personnel People’s lives depend on your proper installation and servicing of Federal Signal products. It is important to read and follow all instructions shipped with this product. Listed below are some other important safety instructions and precautions you should follow: Before Installation or Service... - Page 6 • Locate the light system controls so the VEHICLE and CONTROLS can be operated safely under all driving conditions. SIFMH, SIFMR (Discrete) and SIFMJH,SIFMJR FSJoin ™ (Serial) Rear ILS Light Bar Federal Signal www.fedsig.com...
-
Page 7: Safety Message To Operators Of Warning Light Equipment
Safety Message to Operators of Warning Light Equipment After Installation or Service • After installation, test the light system to ensure that it is operating properly. • Test all vehicle functions, including horn operation, vehicle safety functions, and vehicle light systems, to ensure proper operation. Ensure that the installation has not affected the vehicle operation or changed any vehicle safety function or circuit. - Page 8 • To prevent sliding of light assembly on mounting surface, avoid quick acceleration and hard stops. Failure to follow these precautions may result in property damage, serious injury, or death. RETAIN AND REFER TO THIS MESSAGE. SIFMH, SIFMR (Discrete) and SIFMJH,SIFMJR FSJoin ™ (Serial) Rear ILS Light Bar Federal Signal www.fedsig.com...
-
Page 9: Unpacking The Light Bar
S2 reflectors. Deck (SIFMR) and Hatch (SIFMH) models are available. The light bar ® operates at a nominal input of 13.6 Vdc (11 Vdc minimum). Both Discrete (SIFMH,SIFMR) and Serial (SIFMJH, SIFMJR FSJoin ) control are available as configured options ™... -
Page 10: Figure 1 Dip Switch Locations The Control Boards Of The Serial Controlled Ils
If powering other devices, such as the Six-Button Serial Controller, set DIP Switch 4 to ON. For more information, see the instructions included with the network-powered device. SIFMH, SIFMR (Discrete) and SIFMJH,SIFMJR FSJoin ™ (Serial) Rear ILS Light Bar Federal Signal www.fedsig.com... -
Page 11: Control Wires For The Serial Interface Module
Control Wires for the Discrete-Wire SIFM ILS Control Wires for the Serial Interface Module The serially controlled SIFM SpectraLux ILS connects to a Federal Signal Convergence ® Network Siren/Controller or to the Serial Interface Module. Table 2 shows the default functions of control wires from the Serial Interface Module. -
Page 12: Programming The Discrete-Wire Sifm Ils
Hold the wire to 12 Vdc (+BAT) more than five seconds to reset all settings to the factory defaults and also perform an LED scan. SIFMH, SIFMR (Discrete) and SIFMJH,SIFMJR FSJoin ™ (Serial) Rear ILS Light Bar Federal Signal www.fedsig.com... -
Page 13: Testing The Serial Sifm Ils Controls
Wiring the SIFM ILS in the Vehicle Testing the Serial SIFM ILS Controls LIGHT HAZARD: To be an effective warning device, an emergency warning system produces bright light that can be hazardous to your eyesight when viewed at a close range. Do not stare directly into this lighting product at a close range, or permanent damage to your eyesight may occur. -
Page 14: Maintaining The Sifm Ils
Failure to follow this warning can damage the domes and reflectors and may result in bodily injury or death to you or others. SIFMH, SIFMR (Discrete) and SIFMJH,SIFMJR FSJoin ™ (Serial) Rear ILS Light Bar Federal Signal www.fedsig.com... -
Page 15: Servicing The Sifm Ils
1. Remove the light bar from the vehicle according to the vehicle-specific installation instructions included with the SIFM ILS. 2. See Figure 3 on page 16. Remove the cover on SIFMH models. 3. Disconnect the cables. For the power/ground connector, press the tabs with a pen or small screwdriver and remove the wires. -
Page 16: Figure 3 Exploded View Of Sifmh Ils (Vehicle-Specific)
Servicing the SIFM ILS Figure 3 Exploded view of SIFMH ILS (vehicle-specific) SIFMH, SIFMR (Discrete) and SIFMJH,SIFMJR FSJoin ™ (Serial) Rear ILS Light Bar Federal Signal www.fedsig.com... -
Page 17: Getting Technical Support And Service
Getting Repair Service Getting Technical Support and Service For technical support and service, please contact: Service Department Federal Signal Corporation Phone: 1-800-433-9132 Fax: 1-800-343-9706 Email: empserviceinfo@fedsig.com www.fedsig.com Getting Repair Service The Federal Signal factory provides technical assistance with any problems that cannot be handled locally. -
Page 18: Ordering Replacement Parts
Square Split Grommet 7011246A-06 #10 Type B Steel Pan Head Torx Screw 7011162-06 10-32 TT Black Pan Head 6-Lobe Screw Figure 4 Rear SIFM shroud assembly SIFMH, SIFMR (Discrete) and SIFMJH,SIFMJR FSJoin ™ (Serial) Rear ILS Light Bar Federal Signal www.fedsig.com... -
Page 19: Figure 5 Exploded View Of Rear Sifm
Ordering Replacement Parts Figure 5 Exploded view of Rear SIFM Installation, Maintenance, and Service Manual Federal Signal www.fedsig.com... - Page 20 2645 Federal Signal Drive University Park, Illinois 60484-3167 www.fedsig.com Customer Support Police/Fire-EMS: 800-264-3578 • +1 708 534-3400 Work Truck: 800-824-0254 • +1 708 534-3400 Technical Support 800-433-9132 • +1 708 534-3400...