Table of Contents
Advertisement
1. Unclip and remove the A/C vents from
the factory radio panel. (Figure A)
2. Remove the factory display from the
factory bracket assembly. (Figure B)
3. Cut and remove the (2) tabs on the
bottom of the factory display. (Figure C)
KIT PREPARATION
(Figure A)
(Figure B)
(Figure C)
4. Clip the A/C vents, removed from Step 1,
onto the radio trim panel. (Figure D)
5.
Install the (2) panel clips, and the
factory passenger airbag light, to the
passenger airbag light panel. (Figure E)
Continue to Kit Assembly
Detail
(Figure D)
(Figure E)
REV. 11/14/2017 INST99-5843B
3
Advertisement
Table of Contents
