Setting Up; Minimum Distance To The Device; Distance From Walls - Rational iVario Pro L Original Installation Instructions

5 | Setting up

Setting up
5
Risk of crushing during setup
Fingers, hands and feet may be crushed under the device.
Wear suitable protective clothing during setup.
n
Only lift the device via the designated lifting points.
n
Requirements
If you are not setting up the device on plastic feet as standard, observe the
n
instructions and steps in the Setup options section.
5.1

Minimum distance to the device

Minimum distance is not observed
To avoid damage to the device or malfunctions, the device should be set up
with the specified minimum distance from heat sources or open flames.
Damage to the wall at the rear of the device
Water or steam may escape from the safety overflow. Remember this
during setup and check the properties of the wall at the rear of the device.

5.1.1 Distance from walls

No minimum distance is required at the rear of the device.
a
The walls at the installation site are built in accordance with the local fire
safety regulations and are resistant to heat sources.
1. Observe a minimum distance from walls to the left.
24 / 60
CAUTION
NOTE
NOTE
80.06.243_iVario Pro L_XL_IM_V01_en-US