Cancel With Fault Code - Miele professional PG 8055 Operating Instructions Manual

Problem solving guide

Cancel with fault code

If a programme is cancelled and a fault code appears, e.g.
represents a number), there could be a serious technical fault.
In the event of a programme being cancelled and a fault code being shown:
Switch the dishwasher off with the  button.

Wait approximately 10 seconds before switching the dishwasher on again with the

 button.
Start the previously selected programme again.

If the same error message appears again:
Make a note of the error message.

Switch the dishwasher off with the  button.

Contact the Miele Customer Service Department.

Please also read the notes regarding the following fault codes.
Problem
Fault 403-405
Fault 406-408
Fault 412-414
Fault 492, 504, 541
Fault 550
74
Cause and remedy
Check water inlet
If
is checking the water intake approx. every 30 seconds. If,
after three attempts, water is not getting into the
dishwasher, one of these fault numbers will appear in the
display and the programme will be cancelled.
Open the stopcock fully.

Switch the dishwasher back on.

Select the programme you want.

Press the Start/Stop button.

Water inlet fault.
One of these fault numbers will appear in the display if the
flow pressure is too low and the programme will be
cancelled.
The flow pressure at the water intake point is too low

(see "Technical data"). Contact Miele Service for advice.
Water inlet fault.
One of these fault numbers will appear in the display if the
flow pressure is too high and the programme will be
cancelled.
The flow pressure at the water intake point is too high

(see "Technical data"). Contact Miele Service for advice.
The programme has not started properly. There might be
water in the wash cabinet.
Clean the filter combination (see "Cleaning and care").

Clean the non-return valve (see "Maintenance").

The Waterproof system has reacted.
Close the stopcock.

Call the Miele Service Department.

Fault XXX
appears in the display, the control unit
(where XXX