Digital Equipment DEC 3000 600 AXP Service Information page 100

Entering/Exiting Console and Service Mode
Exiting Service
Mode
4–12
Service mode can be exited by issuing one of the following
console commands at the console prompt.
BOOT and CONTINUE cause you to exit the diagnostic
environment and enter program mode.
SET DIAG_SECTION 1 keeps you in the diagnostic
environment.
• BOOT
Issuing the BOOT command initiates a system bootstrap
operation. See Chapter 13.
• CONTINUE
Issuing the CONTINUE command clears the RC State Flag
bit and resumes processor execution. See Chapter 13.
If the memory contents changed while you were in
service mode, this command causes a failure and should
not be used.
• SET DIAG_SECTION 1
Issuing the SET DIAG_SECTION 1 command selects console
mode.
Note
Note