Page 1
10 Gbps XFP fiber port. Note: The CX4 and XFP interface cards are applicable to multiple models of H3C switches, and the switch models that each of them applies to may update with time. For the latest information, contact H3C technical support or marketing...
Page 2
Each LSPM1CX2P interface card provides two 10 Gbps copper ports and supports CX4 standards. You can connect a CX4 port to another CX4 port through a CX4 cable provided by H3C. For more information about the supported CX4 cables, see Table 2 .
Page 3
The port is not up. Note: Port LED of the LSPM1CX2P interface card is not affected by the port mode switching button on your switch. For more information about the port mode switching button, see the installation guide of the switch.
Page 4
1550 80km M1550 (49.71 mi.) Note: H3C recommends that you use XFP transceiver modules of H3C on the LSPM1XP2P. The types of XFP transceiver modules may update with time. For information about them, contact H3C technical support or marketing staff.
Page 5
LSPM1XP1P Appearance of the interface card Figure 3 Front panel of the LSPM1XP1P interface card Description of LSPM1XP1P Each LSPM1XP1P interface card provides one 10-Gigabit XFP fiber port. You can insert an XFP transceiver module into the port to connect it to another XFP port through an optical fiber. For more information about the supported XFP transceiver modules and fibers, Table 4 Description of LEDs...
Installing the interface card to the switch Note: The procedure of installing the interface card to different models of H3C switches is similar. This manual takes the S5500-28C-EI switch as an example. Follow these steps to install the interface card to the switch:...
Page 7
until the interface card is in close contact with the switch, as shown in Figure 5 (4) Tighten the captive screws with a Phillips screwdriver to fix the interface card. Figure 5 Install an interface card (II) Caution: Keep the removed filler panel properly for future use. When tightening the fastening screws at both sides of the interface card with a screwdriver or an electric screwdriver, make sure that the torque is not bigger than 0.4 N-m.
Page 8
Installing an XFP transceiver module To avoid component damage caused by improper installation, carefully read the H3C Pluggable SFP/SFP+/XFP Transceiver Modules Installation Guide from the H3C's website before installing the XFP transceiver modules. Installing and removing the dedicated CX4 cable...
Removing the dedicated CX4 cable Follow these steps to remove the dedicated CX4 cable: (1) Wear an ESD-preventive wrist strap and make sure the ESD-preventive wrist strap properly grounded. (2) Holding the plug of the CX4 cable, pull the handle at the end of the plug to horizontally unplug the plug of the CX4 cable from the CX4 port of the switch.
Hangzhou H3C Technologies Co., Ltd. provides customers with comprehensive technical support and service. If you purchase the products from the sales agent of Hangzhou H3C Technologies Co., Ltd., please contact our sales agent or technical personnel. Address: 310 Liuhe Road, Zhijiang Science Park, Hangzhou, Zhejiang Province, P.
Need help?
Do you have a question about the LSPM1CX2P and is the answer not in the manual?
Questions and answers