Memory Functions - Nissei DS-400 Instructions Manual

Beep sounds and the inflation mark "
flash.
4
Set AIR CONTROL VALVE to CONSTANT AIR
RELEASE SIDE.
Rapidly squeeze INFLATION BULB to inflate
5
the cuff to 30-40 mmHg above your systolic
pressure or if not known to approximately
180 mmHg.
Gently place INFLATION BULB on the table.
6
The displayed value (pressure) decreases.
The pulse is indicated by heart mark "
synchronizing beep.
Long beep sounds and the deflation mark
" " flashes as the measurement
completes.
Set AIR CONTROL VALVE to RAPID EXHAUST
7
SIDE and release air from the cuff.
Maximum (SYS:systolic) and minimum
(DIA:diastolic) blood pressures and pulse
rate (PUL) are displayed.
The measured data will automatically be stored in
the memory. When a measurement resulted in an
error, it will not be stored.
Press POWER BUTTON to turn off the power.
8
If you forget to turn off the unit, it will be automatically
turned off after 3 minutes.

MEMORY FUNCTIONS

The memory can store up to 30 measurements and their average. When the number of
measurements exceeds 30, the oldest data will be replaced by the newest data.
MEASUREMENT PROCEDURES
" starts to
Stopping Measurement
Set AIR CONTROL VALVE to
RAPID EXHAUST SIDE and
press POWER BUTTON.
Set AIR CONTROL VALVE to
RAPID EXHAUST SIDE and
release air from the cuff.
" with
flashes again during the
measurement, start squeezing
INFLATION BULB to inflate again
to a level about 30 mmHg higher
in 4 sec., or the "Err" appears on
the display.
Do not take measurements
repeatedly for congestion
of blood could result in
false measurement. Let
your arm rest for at least 5
minutes.
- 12 -
OVER-
PRESSURIZATION
See page 13.
If the inflation mark
See page 13.
fig.4