Wan Remote Mount Antenna - Honeywell Thor VM2 Reference Manual

WAN Remote Mount Antenna

The WAN remote mount antenna can be either a magnetic mount or an adhesive mount antenna.
Magnetic Mount WAN Antenna
The Remote Antenna Installation Kit consists of the WAN antenna and an extension cable. The remote antenna is mounted on
the top of a forklift, truck or other vehicle and cabled to the Thor VM2 inside the vehicle.
1. Locate a mounting position on highest point on the vehicle, following these precautions:
The antenna must be mounted so the antenna is not damaged while the vehicle or any of its parts are
l
moving.
2. Clean the area where the antenna is to be mounted.
3. If using an adhesive mount antenna, remove the protective backing paper from the adhesive on the antenna.
4. Position the antenna on the vehicle.
5. Attach the one end of the coaxial cable to the antenna and the other end to the connector on the vehicle mounted Thor
VM2.
6. Use cable ties to secure the coaxial cable to the vehicle as necessary. Make sure the cable is routed so it is not
damaged by any moving parts of the vehicle.
Adhesive Mount WAN Antenna
1. To extension cable
2. To antenna
3. To Thor VM2 antenna
connector
4-21