Step 3 - Attach Adapter Bracket; Step 4 - Place The Thor Vm2 Into The Dock - Honeywell Thor VM2 Reference Manual

Step 3 - Attach Adapter Bracket

Note: For the steps below, always place the lock washer on the bolt before the flat washer.
1. Attach the Adapter Bracket to the Thor VM2 dock using four each M5x16mm bolt, M5 lock washer and M5 flat washer.
Torque to 35 in/lbs (4.0 N/m).
2. Attach the Thor VM2/Adapter Bracket assembly to the U Bracket using 4 each 1/4-20x5/8 bolt, 1/4 lock washer and 1/4
flat washer.
3. If the Thor VM2 is not already installed in the dock:
a. Locate the lip on the top rear of the Thor VM2.
b. Slide this lip over the top of the Dock. Slide the Thor VM2 from side to side on the Dock to make sure it fully
engages on the lip of the Dock. If the Thor VM2 cannot be slid side to side, the lip is engaged.
c. Pull the quick release lever on the Thor VM2 down and push the Thor VM2 against the Dock.
d. Release the quick release lever.
4. Adjust the Thor VM2 to the desired viewing angle.
5. Torque the 14-20 bolts to 50 in/lbs (5.6 N/m).

Step 4 - Place the Thor VM2 into the Dock

If the Thor VM2 is not already mounted to the Dock, place the
3-6
Thor VM2 in the dock.