Main Menu No.8: System Test; Sp Table; Sp8-1: Download Main Firmware - Ricoh JP3000 Service Manual

MAIN MENU NO.8: SYSTEM TEST

5.9 MAIN MENU NO.8: SYSTEM TEST

5.9.1 SP TABLE

No.
8-1 Download main firmware
8-2 Upload main firmware
8-10 Test patterns
8-20 Free run - scanner
8-21 Paper feed (15 rpm)
8-22 Free run - paper feed (15 rpm)
8-30 All indicators on the panel

5.9.2 SP8-1: DOWNLOAD MAIN FIRMWARE

Purpose: This upgrades the main firmware using a flash memory card.
1. Before downloading new firmware, check the current version with SP1-70 (☛
5.2.2).
2. Prepare a flash memory card with the latest firmware.
3. Turn off the main switch and disconnect the power cord.
4. Remove the rear card cover.
5. Plug the flash memory card into the connector on the MPU.
6. Connect the power cord, then turn on the main switch.
7. Access SP8-1. Using the "1" key, select "Ld".
8. Press the Enter key. (It takes about 2.0 minutes to complete.)
9. Check that the "End" is displayed.
10. Turn off the main switch, and remove the flash memory card.
Menu Items
5-14
31 October 2001
Default Settings
No No/Ld (☛ 5.9.2)
No No/Ld (☛ 5.9.3)
6 1 to 9 (☛ 5.9.4)
Off Off/On
0 (☛ 5.9.5)
0 (☛ 5.9.6)
- Press # key