Table of Contents
Advertisement
How to Spray
Use only disinfectants approved for
spray application.
Fumes from disinfectants with alcohol
active ingredients, or from other
flammable disinfectants, can explode or
ignite. Pump motor generates sparks. To
prevent fumes from exploding or igniting:
•
Keep pump at least 20 ft from spray
area.
•
Do not spray pump.
•
Keep spray area well-ventilated.
•
Keep a good supply of fresh air moving
through the area.
Choose Your Spray Tip
To avoid serious injury from skin injection,
do not put your hand in front of the Spray
Tip when installing or removing the Spray
Tip and Spray Tip Guard.
Your sprayer comes with 3 Spray Tip sizes:
Fine
Medium
Coarse
Select the appropriate Spray Tip size to
provide the acceptable spray of disinfectant.
Refer to the disinfectant label for
manufacturer's recommendations.
To prevent Spray Tip leaks, make certain
Spray Tip and Spray Tip Guard are installed
properly.
1.
Perform Pressure Relief Procedure,
page 12.
3A7656C
LP617
LP619
LP621
How to Spray
2.
Use Spray Tip (A) to align gasket and
seal (B) in the Spray Tip Guard (C).
3.
Insert Spray Tip into Spray Tip Guard.
Verify Spray Tip is forward in the SPRAY
position.
4.
Screw Spray Tip Guard assembly onto
Spray Gun and tighten.
17
Advertisement
Table of Contents
