Table of Contents
Advertisement
4
• Connect the refrigerator power cord plug to
Step
Connect
Power
5
The icemaker will not begin to operate until it
reaches its operating temperature of 15ºF.
S tep
(-9ºC.) or below.
• Lower the feeler arm to the ON position and
Start
automatically.
Icemaker
• Make sure the ice bin is pushed back all the
• Discard the first few batches of ice cubes to
NOTE: The icemaker may double-cycle when
it first starts, causing some water spillage from
the icemaker into the ice bucket. This is
normal and should not happen again.
Step
6
• Push the refrigerator into position being
Roll
• Remove internal packing materials and set
Refrigerator
Into Position
7
• Remove the base grille by gasping it at the
Step
• Turn the roller adjusting screws clockwise to
Level The
Refrigerator
NOTE: When leveling, you can improve door
closure by raising the front approximately
5/8" from the floor.
• Replace base grille by aligning prongs with
properly grounded receptacle.
the icemaker will begin operation
way to the stops on the shelf below the
icemaker.
be sure that any remaining impurities in the
water line will be flushed out.
careful not to entangle power cord. Arrange
the coil of copper tubing so that is does not
vibrate against the back of the refrigerator.
shelves to desired positions.
bottom and pulling outwards.
raise the refrigerator, counterclockwise to
lower it. Use an adjustable wrench (3/8" hex
head bolt) or pliers.
clamps on the cabinet and pushing forwards
until the grille snaps into place.
Installation
Stainless Steel Refrigerators
Clamp
Prong
7
Advertisement
Table of Contents
