Grounding The Housing To The Pedestal - Pepperl+Fuchs VisuNet GXP Series Manual

VisuNet GXP
Mechanical Installation
3.3.6

Grounding the Housing to the Pedestal

Warning!
Customer responsibility to verify grounding path
Check the grounding path after completing system installation.
The AG1 housing comes with a pre-installed PE wire that is connected from the inside-top of
the housing to the inside-back of the housing. The pedestal comes with a pre-installed PE wire
that you must route from the pedestal into the housing (see see chapter 3.3.3).
Connecting the PE Wires
1.
Remove the nuts and washers from the PE stud on the inside-back of the AG1 housing.
2.
Connect the pre-installed PE wires from the the housing and pedestal to the PE stud.
29