Cleaning And Drying; Dome Cleaning Procedure - Leica BLK2GO User Manual

6.4
Damp products
Housing parts of
product and accesso-
ries
Charger and AC/DC
power supply
Cables and plugs
6.5
General cleaning
information
Dust and debris on
the dome
Cleaning of the cam-
era lenses
Care and Transport

Cleaning and Drying

Dry the product, the transport case, the foam inserts and the accessories at a
temperature not higher than 40°C /104°F and clean them. Remove the battery
cover and dry the battery compartment. Do not repack until everything is com-
pletely dry. Always close the mission bag when using in the field.
Never touch the dome with your fingers.
•
• Only use a clean, soft, lint-free cloth for cleaning. If necessary, moisten the
cloth with water or pure alcohol. Do not use other liquids; other liquids
may attack the polymer components.
Use only a clean, soft, lint-free cloth for cleaning.
Keep plugs clean and dry. Blow away any dirt lodged in the plugs of the con-
necting cables.

Dome Cleaning Procedure

The dome must be kept clean. The instructions must be followed as described
in this chapter to clean the dome.
CAUTION
Before any cleaning procedure, ensure that the instrument is switched off and
the battery has been removed.
Using a compressed gas duster (e.g., UltraJet® 2000 Gas Duster or UltraJet®
Compressed CO2 Duster), remove dust and debris from surface of the dome.
☞ Never rub off dust or debris as this will scratch the glass and so possi-
bly cause permanent damage to the special optical coatings.
Soiling of the glass pane can cause extreme measurement errors and therefore
useless data!
☞ All soiling that is visible on the glass pane has to be removed, except
for single small dust particles that adhere inevitably.
For the glass cleaning procedure, the wet and dry lens cleaner
Green Clean LC-7010 is recommended (www.green-clean.at/en.html).
Clean the glass pane regularly with the recommended cleaning tissue:
33