Table of Contents
Advertisement
• Make sure to periodically check correct operation of all the safety devices and the insulation
of electrical cables, which must be replaced if damaged.
• Repair and extraordinary Maintenance have to be carried out by specialised authorised
personnel provided with all the appropriate personal protection equipment, tools, utensils
and ancillary means.
• Never operate the machine, removing, modifying or tampering with the guards, protection
or safety devices.
• Before carrying out any operation on the machine, always consult the manual which gives
the correct procedures and contains important information on safety.
• When an error code (see H.1 Anomaly table chapter) which depends on unexpected
appliance stop appears on the display, turn off the appliance from power supply and have
serviced by a qualified technician.
Residual risks
• The machine has several risks that were not completely eliminated from a design
standpoint or with the installation of adequate protection devices. Nevertheless, through
this manual the Manufacturer has taken steps to inform operators of such risks, carefully
indicating the personal protection equipment to be used by them. In order to reduce the
risks, provide for sufficient spaces while installing the unit.
To preserve these conditions, the areas around the machine must always be:
– kept free of obstacles (e.g. ladders, tools, containers, boxes, etc.);
– clean and dry;
– well lit.
For the Customer's complete information, the residual risks remaining on the machine are
indicated below: such situations are deemed improper and therefore strictly forbidden.
Residual risk
Slipping or falling
Burns/abrasions (e.g. heating
elements)
Electrocution
Sudden closing of the oven door
Sudden closing of the lid/door/
oven door (if present, depending
on the appliance type)
Falling from above
Tipping of loads
Description of hazardous situation
The operator can slip due to water or dirt on the floor
The operator deliberately or unintentionally touches
some components inside the machine without using
protective gloves
Contact with live parts during maintenance
operations carried out with the electrical panel
powered
The operator for normal machine use could
suddenly and deliberately close the oven door
The operator for normal machine use could
suddenly and deliberately close the lid/door/oven
door (if present, depending on the appliance type)
The operator intervenes on the machine using
unsuitable systems to access the upper part ( e.g.
rung ladders or climbs on it)
When handling the machine or the packing
containing it, using unsuitable lifting systems or
accessories or with the unbalanced load
7
Advertisement
Table of Contents
