General Safety Rules - Electrolux Combi TOUCH Series User Manual

• Never operate the machine, removing, modifying or tampering with the guards, protection
or safety devices.
• Do not make any modifications to the parts supplied with the appliance.
• Several illustrations in the manual show the machine, or parts of it, without guards or with
guards removed. This is purely for explanatory purposes. Do not use the machine without
the guards or with the protection devices deactivated.
• Do not remove, tamper with or make illegible the safety, danger and instruction signs and
labels on the machine.
• Before servicing, disconnect the electrical service and place a red tag at the disconnect
switch to indicate work is being done on that circuit.
• The A-weighted emission sound pressure level does not exceed 70 dB(A).
• Turn the appliance off in case of fault or poor operation.
• Do not use products (even if diluted) containing chlorine (sodium hypochlorite, hydrochloric
or muriatic acid, etc.) to clean the appliance or the floor under it.
• Do not spray water or use water jets or steam to clean the equipment.
• Do not spray aerosols in the vicinity of this appliance while it is in operation.
• Never check for leaks with an open flame.
• Install the appliance under conditions of adequate ventilation in order to provide a suitable
air change per hour. The appliance must be installed under ventilation hood only. Make
sure that the ventilation system always remains operational and efficient for the entire
period of time during which the equipment is operating.
• Improper ventilation of the oven can be hazardous to the health of the operator; and will
result in operational problems, unsatisfactory cooking results, and possible damage to the
equipment. Damage sustained as a direct result of improper ventilation OF THE OVEN will
not be covered by the Manufacturer's warranty.
• Do not obstruct the flow of combustion and ventilation air.
A.4

General safety rules

Protection devices installed on the machine
• The guards on the machine are:
fixed guards (e.g. casings, covers, side panels, etc.), fixed to the machine and/or frame with
screws or quick-release connectors that can only be removed or opened with tools.
Therefore the user must not remove or tamper with such devices. The Manufacturer
declines any liability for damage due to tampering or their non-use.
Instructions for use and maintenance
• Risks mainly of a mechanical, thermal and electrical nature exist in the machine. Where
possible the risks have been neutralised:
– directly, by means of adequate design solutions.
– indirectly by using guards, protection and safety devices.
• During maintenance, always carried out by personnel qualified, several risks remain, as
these could not be eliminated, and must be neutralised by adopting specific measures and
precautions.
• Do not carry out any checking, cleaning, repair or maintenance operations on moving parts.
Workers must be informed of this prohibition by means of clearly visible signs.
• To guarantee machine efficiency and correct operation, periodical maintenance must be
carried out according to the instructions given in this manual.
6