Electrolux Combi TOUCH Series User Manual page 59

Anom- Type of
Description
aly anomaly
BSOt Stops Boiler SSR NTC over-
cooking temperature (NTC4)
cycle
Cdo Stops Cleaning drawer
cleaning absent
CFbL Warning Cooling fan failure
CntC Stops Cavity SSR NTC fail-
cooking ure (NTC3)
CPUA Stops oven ACS micro does not
communicate
CPUt Stops oven TC micro does not
communicate
CSHt Warning Cavity SSR NTC high
temperature (NTC3)
CSOt Stops Cavity SSR NTC over-
cooking temperature (NTC3)
cycle
Possible causes
• Inlet air filter dirty;
• Cooling fan failure;
• Cooling inlet air sucking
warm/hot air;
• Oven installed by hot
machine,
• Steam/Heat leakage in
the electronic
compartment.
• The cleaning drawer has
not been inserted or
properly inserted in its
housing;
• The detection devices
(magnet/magnetic reed)
have issues.
• Cooling fan motor over-
load due to dirt or
oxidation
• Other electrical/mechani-
cal issue
• Connector failure;
• NTC sensor failure;
• PCB failure;
PCB failure.
PCB failure.
• Inlet air filter dirty;
• Cooling fan failure,
• Cooling inlet air sucking
warm/hot air;
• Oven installed by hot
machine;
• Steam/Heat leakage in
the electronic
compartment;
• Inlet air filter dirty;
• Cooling fan failure;
• Cooling inlet air sucking
warm/hot air;
• Oven installed by hot
machine;
• Steam/Heat leakage in
the electronic
compartment;
Actions
The oven can continue to work in recovery
mode: cooking cycles will not use the boiler.
• Do not switch the oven Off;
• Wait for the temperature to decrease;
• Clean the inlet air filter;
• Check with a thin strip of paper whether a
consistent air flow can be detected at the
cooling air inlet: if not, call service;
• Check if the inlet cooling air may be affected
by heat produced in the kitchen (in case the
oven is located by hot appliances, stop work-
ing with those appliances and inform
Service);
• If the error persists, call Service.
The oven can continue to cook but cleaning
cycle could not be performed until the drawer will
be in place;
• Ensure that the cleaning drawer is in its
housing and inserted properly in order to
trigger the detection devices;
• If the error persists, clean the oven manually
and call Service.
The oven will be operative until the electronic will
reach the critical temperature.
Call Service
• Restart the oven;
• If the error persists, call Service.
• Restart the oven;
• If the error persists, call Service.
• Restart the oven;
• If the error persists, call Service.
• Do not switch the oven Off;
• Wait for the temperature to decrease;
• Clean the inlet air filter;
• Check with a thin strip of paper whether a
consistent air flow can be detected at the
cooling air inlet: if not, call Service;
• Check if the inlet cooling air may be affected
by heat produced in the kitchen (in case the
oven is located by hot appliances, stop work-
ing with those appliances and inform
Service);
• If the error persists, call Service.
The oven can continue to work in recovery
mode: cooking cycles will not use the boiler.
• Do not switch the oven OFF;
• Wait for the temperature to decrease;
• Clean the inlet air filter;
• Check with a thin strip of paper whether a
consistent air flow can be detected at the
cooling air inlet: if not, call service;
• Check if the inlet cooling air may be affected
by heat produced in the kitchen (in case the
oven is located by hot appliances, stop work-
ing with those appliances and inform
Service);
• If the error persists, call Service.
59