Table of Contents
Advertisement
Anom-
Type of
Description
aly
anomaly
FSnr
Warning
Cooling fan issue
FUXX
Stops oven
Upper cavity motor
(XX = 00
failure
- 17)
GbbU
Stops the
Boiler gas burner
boiler
locked
GbCd
Cycle
Cavity lower burner
paused
locked
GbCU
Cycle
Cavity upper burner
paused
locked
GrCo
Stops
Grease collector valve
cleaning
opened
cycle
HdXX
Stops oven
Valves/pumps
(XX =
activations
01-26)
HFnI
Warning
Humidifier not working
62
Possible causes
• Inlet air filter dirty
• Cooling fan failure
Diagnostic according to
error number (from 00 to 17)
displayed.
• Air in gas supply;
• Gas supply is closed;
• Issue with the electric
supply of the burner
system;
• Burner system internal
failure;
• Air in gas supply;
• Gas supply is closed;
• Issue with the electric
supply of the burner
system;
• Burner system internal
failure;
• Air in gas supply;
• Gas supply is closed;
• Issue with the electric
supply of the burner
system;
• Burner system internal
failure;
Misuse
Diagnostic according to
error number (from 01 to 26)
displayed.
• Water missing;
• ISG circuit obstruction.
Actions
• Clean inlet air filter;
• Check with a thin strip of paper whether a
consistent air flow can be detected at the
cooling air inlet: if not, call Service.
Switch the oven OFF/ON;
If the error persists, manually clean the oven
cavity and call Service.
The oven can continue to work both in convec-
tion and ISG mode.
To recover full boiler functionality:
• Switch the oven OFF/ON.
• If the error occurs at the cycle start, call
Service.
• If the error occurs after 5 ignition attempts:
1. check the gas supply main valve is open
2. reset the error and attempt new cycle
3. if the error persists, switch OFF/ON the
oven and attempt new cycle again;
4. if the error persists, call Service
The oven will not operate until restoring the
burner functionality.
To recover the functionality:
• Switch the oven OFF/ON.
• If the error occurs at the cycle start, call
Service.
• If the error occurs after 5 ignition attempts:
1. check the gas supply main valve is open
2. reset the error and attempt new cycle
3. if the error persists, switch OFF/ON the
oven and attempt new cycle again;
4. if the error persists, call Service
The oven will not operate until restoring the
burner functionality.
To recover the functionality:
• Switch the oven OFF/ON.
• If the error occurs at the cycle start, call
Service.
• If the error occurs after 5 ignition attempts:
1. check the gas supply main valve is open
2. reset the error and attempt new cycle
3. if the error persists, switch OFF/ON the
oven and attempt new cycle again;
4. if the error persists, call Service
Ensure to close the grease collector drain valve
before restarting the cleaning cycle.
Switch the oven OFF/ON;
If the error persists, follow instructions displayed.
If the error persists, manually clean the oven
cavity and call Service.
The oven has detected a problem with the
humidifier.
Verify the water supply valve is fully open and
the water filler has no obstructions. Clean it if
needed.
If the problem persists, call Service.
Advertisement
Table of Contents
