C.fn: Setting Custom Functions; Control With The Camera's Menu Screen - Godox V1C Instruction Manual

C.Fn: Setting Custom Functions

The following table lists the available and unavailable custom
functions of this flash.
C.Fn Custom Functions
Function
Custom
Function
Signs
m/ft Distance indicator
AF AF-assist beam
STBY Auto sleep setting
RX STBY Receiver auto
power off timer
SCAN Scan the spare
channel
CH Channel setting
ID Wireless ID
BEEP Beeper
LIGHT Backlighting time
LCD LCD contrast ratio
FEB ACL FEB auto cancel
TX Transmitter
unit control
1. Press<MENU> Button until C.Fn menu is displayed. The "Ver
x.x" in the top-right corner refers to the software version.
2. Select the Custom Function No.
● Turn the Select Dial to select the Custom Function No.
3. Change the Setting.
● Press Set Button and the Setting No. blinks.
● Turn the Select Dial to set the desired number. Pressing Set
Button will confirm the settings.
● After you set the Custom Function and press <MENU> button,
the camera will be ready to shoot.
4. In the C.Fn states, long press the "Clear"button for 2 seconds
until "OK"is displayed on the panel, which means the values in
C.Fn can be reset.
- 55 -
Setting No. Settings & Description
m
m
feet
ft
ON
ON
OFF
OFF
ON
ON
OFF
OFF
60min
60min
30min
30min
OFF
OFF
Start to find the spare
START
channel
Choose channels
01-32
from 01-32
Off
OFF
Choose any figure
01-99
from 01-99
ON
ON
OFF
OFF
Off in 12 sec.
12sec
Always off
OFF
Always lighting
ON
7 levels
-3~+3
ON ON
OFF
OFF
OFF
ON

Control with the Camera's Menu Screen

If the camera flash is attached to an EOS camera which has a
speedlite control function, the flash can be controlled using the
camera's menu screen. For the menu operation procedure, refer to
your camera's instruction manual.
●
Setting Camera Flash Functions
The following flash functions are settable according to different
flash modes.
1. Flash mode
2. Shutter sync (1st/2nd curtain, high speed sync)
3. FEB
4. Flash exposure compensation
5. Flash firing
6. Clear camera flash's settings
●
Custom Functions of Camera Flash
C.Fn-00, C.Fn-01, C.Fn-03, C.Fn-08, C.Fn-10, C.Fn-20, C.Fn-22.
Clear All Flash Custom Functions
Flash function settings screen
Flash function settings
E-TTL II
Flash mode
Shutter syne. 1st curtain
- 3 . 2 . 1 . 0 . 1 . 2 . 3
FEB
-
- . . . . . .
Flash exp. comp 3 2 1 0 1 2 3
-
E-TTL II Evaluative
Flash firing Enable
Clear Speedlite Settings
* Screens from the EOS-1D Mark III.
●
If flash exposure compensation has already been set with
the camera flash, flash exposure compensation cannot be
set with the camera. To set it with the camera, the camera
flash's flash exposure compensation must be set to zero.
●
If any Flash Custom Functions and flash settings other
than flash exposure compensation have been set by both
the camera and the flash, the latest settings will take effect.
Flash C.Fn settings screen
Flash C.Fn settings
1
Auto powe off
0:Enabled
1:Disabled
-
0 1 2 3 4 5 6 7 8 9 10 11 12 13
0 0 0 0 0 0 0 0 0 0 0 0 0 0
- 56 -