C.fn: Setting Custom Functions; Protection Function - Godox V1 N PRO Manual

C.Fn: Setting Custom Functions

Press the menu button to enter C.Fn settings.
Custom Function Signs Function
m/ft Distance indicator
AF AF-assist beam
STBY Auto sleep setting
RX STBY Receiver auto
power off timer
SCAN Scan the spare
channel
CH Wireless Channel
ID ID
BEEP Beeper
LIGHT Backlighting time
LCD LCD contrast ratio
Note：
1. The "Verx.x" in the top-right corner refers to the software version.
2. Turn the select dial to select the custom function No. and its parameters.
3. Press set button to select the custom function No. and confirm its setting.
4. After you set the custom function and press <MENU> menu button, the camera
will be ready to shoot.
5. Press and hold the function button 1 <CLEAR> in the MENU interface until "OK" is
displayed on the panel, which means the parameters in C.Fn are reset.

Protection Function

Over-Temperature Protection
To avoid overheating and deteriorating the flash head, do not fire more
than 100 continuous flashes in fast succession at 1/1 full power. After 100
continuous flashes, allow a rest time of at least 10 minutes.
If you fire more than 100 continuous flashes and then fire more flashes
in short intervals, the inner over-temperature protection function may be
activated and make the recycle time over 10 seconds. If this occurs, allow a
rest time of about 10 minutes, and the flash unit will then return to normal.
When the over-temperature protection is started, <> is shown on the LCD
display.
Options Settings & Description
m m
ft Feet
ON ON
OFF OFF
ON ON
OFF OFF
60min Power off automatically
after 60 minutes of idle
use when the flash is set
30min as a receiver unit.
Power off automatically
after 30 minutes of idle
use when the flash is set
as a receiver unit.
OFF OFF
START Start to scan the spare
channel
01-32 Choose channels from
01-32
OFF OFF
01-99 Choose any figure from
01-99
ON ON
OFF OFF
12sec Off in 12 sec.
OFF Always off
ON Always lighting
-3~+3 7 levels
44
Number of flashes that will activate over-temperature protection:
Power Output Level
1/1
1/2 (+0.1~+0.9)
1/4(+0.1~+0.9)
1/8(+0.1~+0.9)
1/16(+0.1~+0.9)
1/32(+0.1~+0.9)
1/64(+0.1~+0.9)
1/128(+0.1~+0.9)
1/256(+0.1~+0.9)
Note: Numbers of flashes of over-temperature protection are different in different zoom values
and different levels.
Number of flashes that will activate over-temperature protection in HSS
mode:
Power Output Level
1/1
1/2 (+0.1~+0.9)
1/4(+0.1~+0.9)
1/8(+0.1~+0.9)
1/16(+0.1~+0.9)
1/32(+0.1~+0.9)
1/64(+0.1~+0.9)
1/128(+0.1~+0.9)
1/256(+0.1~+0.9)
Number of Flashes
100
150
300
300
1100
3500
3500
3500
3500
Number of Flashes
60
70
100
100
100
100
100
100
100
45