Setting The Communication Channel; Wireless Id Settings; Scan The Spare Channel; Ettl Fully Automatic Wireless Flash Shooting - Godox V1C Instruction Manual

3. Setting the Communication Channel

If there are other wireless flash systems nearby, you can change the
channel IDs to prevent signal interference. The channel IDs of the
Transmitter unit and the Receiver unit(s) must be set to the same.
C.Fn Ver 0.5
SCAN STBY
CH 07
ID
BEEP
CLEAR

4. Wireless ID Settings

Change the wireless channels and wireless ID to avoid interference
for it can only be triggered after the wireless IDs and channels of the
Transmitter unit and the Receiver unit are set to the same.Press the
<MENU> button to enter C.Fn ID. Press the Set Button to choose
OFF channel expansion shutdown, and choose any figure from 01 to
99.

5. Scan the Spare Channel

To avoid the interference of using the same channel by others, this
function can be used: enter the C.Fn settings and find the SCAN
option. When setting it to START, it will scan from 1% to 100%. And
the 8 spare channels will be displayed after the scan is completed.
C.Fn Ver 0.5
SCAN STBY
CH
ID
22 08 32 23
30 21 07 06
BEEP
CLEAR

6. ETTL Fully Automatic Wireless Flash Shooting

Using Automatic Wireless Flash with a Single Receiver Unit
- 49 -
1
Press <MENU> Button to
enter C.Fn CH setting.
2
In C.Fn CH, turn the Select
Dial to choose channel ID
from 1 to 32.
3
Press the Set Button to
confirm.
1
Transmitter Unit Setting
● Attach a
V1C camera
flash on the camera and
set it as the Transmitter
unit.
● X1T-C can also be used as
Transmitter unit. X1T-C can
control V1C 's ZOOM
value when the ZOOM is
adjusted to auto (A) mode.
2
Receiver Unit Setting
● Set the other camera flash
as the wireless Receiver
Unit.
3
Check the communication
channel.
● If the Transmitter unit and
Receiver unit(s) are set to
a different channel, set
them to the same channel.
(Page 49)
4
Position the camera and
flashes.
● Position the camera and
flashes as the picture
shows. (Page 47)
5
Set the Transmitter unit's
flash mode to <ETTL>.
● Set the Transmitter unit's
flash mode to <ETTL>.
● For shooting, <ETTL> will
automatically be set for the
Receiver unit.
● Set the Transmitter unit
flash firing as ON to fire a
flash.
6
Check that the flash is
ready.
● Check that the Transmitter
flash ready indicator is
lightened.
● When the Receiver flash
ready indicator is ready, the
AF-assist beam lighting
area will blinks at 1 second
intervals.
7
Check the flash operation.
● Press the Transmitter
unit's Test Button < >.
● Then, the Receiver unit will
fire. If not, adjust the
Receiver unit's angle
toward the Transmitter unit
and distance from the
Transmitter unit.
- 50 -