Wireless Settings; Transmitter Unit's Flash Off - Godox V1C Instruction Manual

Positioning and Operation Range (Example of wireless flash
shooting)
● Autoflash Shooting with One Receiver Unit
TRANSMITTER
RECEIVER
● Use the supplied mini stand to position the Receiver unit.
● Before shooting, perform a test flash and test shooting.
● The transmission distance might be shorter depending on
the conditions such as positioning of Receiver units, the
surrounding environment and whether conditions.
Wireless Multiple Flash Shooting
You can divide the Receiver units into two or three groups and
perform E-TTL II autoflash while changing the flash ratio (factor). In
addition, you can set and shoot with a different flash mode for each
firing group, for up to 4 groups.
● Auto Shooting with Two Receiver Groups
● Auto Shooting with Three Receiver Groups
A
- 47 -
Transmission distance is about 100m.
A
B
C
B
● Shooting with a Different Flash Mode set for Each Group
A
E-TTL II
B
Manual flash
* The flash mode settings are indicated only as an example

1. Wireless Settings

You can switch between normal flash and wireless flash. For normal
flash shooting, be sure to set the wireless setting to OFF.
Transmitter Unit Setting
Press <
is displayed on the LCD panel.
Receiver Unit Setting
Press <
or <
the LCD panel.

2. Transmitter Unit's Flash OFF

When the Transmitter unit is set to OFF, only the Receiver units will
fire a flash.
1
2
C.Fn Ver 0.5
LIGHT STBY
<
LCD
FEB ACL
<
TX
CLEAR
Ceiling
D
Manual flash
C
Manual flash
> button so that < >
> button so that < >
> are displayed on
Press <MENU> Button to
enter C.Fn Transmitter
setting.
Set Transmitter to ON/OFF
to control the On/Off of the
Transmitter unit.
>：The Transmitter unit flash
firing is ON.
>：The Transmitter unit flash
firing is OFF.
● Even if the Transmitter unit
flash firing is disabled, it
still fires a preflash to
transmit wireless signals.
- 48 -