Additional Safety Instructions - Parkside PHS 160 C4 Translation Of The Original Instructions

G B
4) POWER TOOL USE AND CARE
• Do not force the power tool. Use
the correct power tool for your
application. The correct power tool
will do the job better and safer at the
rate for which it was designed.
• Do not use the power tool if the
switch does not turn it on and
off. Any power tool that cannot be
controlled with the switch is dangerous
and must be repaired.
• Disconnect the plug from the
power source and/or the bat-
tery pack from the power tool
before making any adjust
-ments, changing accessories, or
storing power tools. Such preven-
tive safety measures reduce the risk of
starting the power tool accidentaIly.
• Store idle power tools out of the
reach of children and do not al-
low persons unfamiliar with the
power tool or these instructions
to operate the power tool. Power
tools are dangerous in the hands of
untrained users.
• Maintain power tools. Check
for misalignment or binding of
moving parts, breakage of parts
and any other condition that
may affect the power tool's op-
eration. If damaged, have the power
tool repaired before use. Many acci-
dents are caused by poorly maintained
power tools.
• Keep cutting tools sharp and
clean. Properly maintained cutting
tools with sharp cutting edges are less
Iikely to bind and are easier to control.
• Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, tak-
ing into account the working
8
conditions and the work to be
performed. Use of the power tool for
operations different from those intended
could result in a hazardous situation.
• Hold the device by the insulated
gripping surfaces when perform-
ing work in which the cutting
tool may come into contact with
hidden wiring or its own cord.
Contact with a live wire can also cause
a charge in metal parts of the device
and result in an electric shock.
5) SERVICE
• Have your power tool serviced
by a qualified repair person us-
ing only identical replacement
parts. This will ensure that the safety of
the power tool is maintained.

Additional safety instructions

Warning! Sanding can result
in the formation of hazardous
dusts (e.g. arising from ma-
terials with paints containing
lead, materials containing as-
bestos, metals or some wood
types) which can present a
hazard to the operator or
persons in the vicinity. Make
sure that the workplace is
well ventilated. Always wear
safety goggles, safety gloves
and respiratory protection.
Secure the workpiece. A workpiece
•
that is retained with clamping appli-
ances or a vice is held more securely
than with your hand.
Only use the power tool for dry
•
sanding. Do not scrape moist
materials. Penetration of water into