Use And Operation; Cleaning And Care; Troubleshooting - Klarstein 10029429 Manual

If using the ice maker for the first time (or after a period of inactivity) please discard the first two batches of ice.
This cleans the internal systems of the ice maker.
• Connect the device to a grounded single power socket.
• Press the Power switch to the ON position [I]. The Switch light illuminates and the appliance stm1 to work.
The first 5 minutes is used for the self-inspection of the ice maker. Then it will begins the ice making process.
• ICE FULL: As soon as the ice storage cabinet is full, the indicator on the display panel will light on and the ice
maker will stop automatically. Production resumes once ice has been removed from the cabinet.
• WATER LOW: If water supply is insufficient, the indicator will light on and the ice maker will stop operation
automatically.
• FAULT: If any error or failure occurs, the „FAULT" indicator will light on and the ice production stops. For
further information see „Troubleshooting".
• Switch off the device and disconnect it from power supply (pull the power plug), when it is not in use.
• Do not switch on the device immediately after it stops automatically (caused by insufficient water supply,
ice storage cabinet too full, current interruption). Wait at least 3-5 minutes before restm1 it in order to avoid
damages of the compressor.
• NOTE: If the device is not used for a longer period of time, drain the water from the water tank via the drain
screw at the back of the device (some model no drain screw). Wipe dry the water tank using a dry cloth.
• Always switch off and disconnect the power supply before cleaning.
• Warm, soapy water is recommended for cleaning. Cleaning agents may leave harmful residues.
• DO NOT wash the base unit, instead wipe the exterior with a damp cloth.
• Check regularly the connectors of the water inlet and outlet tubes and drain the little surplus water that may
leak.
• If the ice make will be nnused for a long period, please switch off the power switch and wipe the inner liner
of the ice storage container with a clean rag.
• When plugging or unplugging, the plug should be held by hand and the wires should not be dragged heavily.
Problem
Device does not work
without any lights
coming on.
Device does not
work, only switch light
comes on.

Use and Operation

Cleaning and Care

Troubleshooting

Possible Cause
Power suply is interrup-
ted.
Power supply voltage is
not correct.
Power supply voltage is
not correct.
PCB board damaged.
Solution
Check the power supply.
Cut off the power supply.
Cut off the power supply.
Contact a service agency for repair or replacement.
8