Operation - Klarstein EISZEIT Manual

Ice cube maker
Hide thumbs Also See for EISZEIT:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 15
EN
20

OPERATION

1. Connect the water drain hose to the back of the unit (number 17 in the illustration
sketch, under the fi lling tube), as the moisture in the air may freeze into water if the
unit continues to run but no ice is removed from the unit.
2. Insert the plug of the unit into the socket. Fill with water according to sketch A or B.
Sketch A
Add water manual
Add water by manual.
Note: If the unit is on ice making,indicator
ice,then add water to the water reservoir,but please take out the ice fi rst, then add
one full cup of water so as to avoid overfl ow of water when the ice melt.
3. Press ON/OFF button to start the machine.
4. Water will be pumped into the water tray from the water reservoir automatically,this
takes about 30 seconds
Note: If no water is pumped to the water tray over two cycles but the water in
reservoir is enough, then please open the drain cap, and let several drops water
runs out. Then press ON/OFF button again to restart the unit.
5. Press the SELECT key to select the ice cube size.
Note: when temperature lower than 15 degrees, SMALL is recommended,when
temperature over 30 degrees, LARGE ice is recommended.
Sketch B
A to
water pipe
B to
water faucet
C to unit
Connect unit to water faucet.
is on,but want to make more

Advertisement

Table of Contents
loading

This manual is also suitable for:

10033478

Table of Contents