Operation; Cleaning And Care - Klarstein 10045386 Manual

EN
18

OPERATION

Open the lid and fill the water tank with water.
1
Note: Make sure the water level in the water tank does not rise above the
bottom of the ice basket.
2 Connect the device to the mains.
Press the ON button to turn on the device. The ice maker starts to work.
Note: The ice will come out a few minutes after starting, the ice is soft
3
and wet at the beginning. However, this will change in the course of
operation.
4
Press the OFF button to stop the machine.
5
Pull out the silicone drain plug in the water tank to drain the water.

CLEANING AND CARE

• Always disconnect the power plug from the mains before cleaning.
• Remove the ice holder.
• Clean the inside of the device with a mild detergent, warm water and a soft
cloth.
• Rinse the inside of the device with clear water and drain the water through the
water drain hole by unscrewing the cap.
• The exterior of the device should be cleaned regularly with a mild detergent
and warm water.
• Dry the inside and outside of the device with a soft cloth.
• Drain the water from the water tank if you will not be using the device for a
long period of time.
• Clean both the internal water tank and the large water tank with a mild
detergent, warm water and a soft cloth. Rinse the inside with clean water and
drain the water through the water drain hole by unscrewing the cap. This will
keep the device hygienically clean and ensure that the device works normally.