Getting Started; Operation - Klarstein Icetender Manual

EN
18

GETTING STARTED

1 Take all components out of the packaging.
2 Position the ice maker on a well ventilated place and leave at least 150 mm
distance between the ice maker and the wall. Adjust the feet of the ice maker so that
it is positioned levelly.
Connect one end of the flexible Φ14 plastic corrugated pipe (supplied with the
3
machine) with the water outlet tube on the back of the machine, another pipe end
should be placed in a container for surplus water (prepared by the user himself) or
in the sewer.
4 Connect one end of the water inlet tube (supplied with the machine) with the 3/4
inch screw type connector of the water tap so as to get the drinkable tap water. The
water pressure of the water supply pipe is 1-8 kg/cm
inlet tube should be connected with the screw type connector of the water valve on
the back of the ice maker. Be sure to put the gaskets (supplied with the machine)
into both ends of the water inlet tube before connecting. If it is an ice maker for
purified water, a Φ14 corrugated pipe (supplied with the machine) should be used.
Connect one end of the pipe with the purified water supplier (cold water tap or end
of the water drainage tube of a water dispenser) and another end with the water
valve connector on the back of the ice maker. Make sure that the purified water
outlet position is higher than the top of the ice maker.
Note: Wait at least 12 hours after setting up the ice machine for the first time before
using it for the first time.

OPERATION

1 Plug the power plug of the appliance into the wall outlet. Then press the power
button on the ice machine to start it - the green "run" light will be lit . The "RUN"
indicator light illuminates. The appliance starts operation. All procedures such as
water inlet, ice making, ice dropping and ice storage are automatically controlled
during ice production. If problems occur, the corresponding indicator lights
illuminate (see indicator lights in the "Troubleshooting" section).
2 Only purified drinking water should be used for the appliance. If the "WATER LOW"
indicator light illuminates and no ice is produced, maybe there is air in the water
inlet tube. Disconnect one end of the water inlet tube from the water valve of the ice
cube maker. Open the water inlet switch until water and air run out from the end.
Then quickly reconnect the water inlet tube with the water valve of the appliance.
Note: If the water storage is defective or the water supply system is faulty, the ice
maker will restart automatically in 24 hours. If the problem has not been solved, stop
the appliance and restart it again.
.) The other end of the water
2