Advantech IPC-7120S User Manual page 5

Desktop/wallmount chassis with rich front i/o interfaces for atx motherboard
Table of Contents

Advertisement

28.
CAUTION: Never immerse equipment or electrical connectors in water or other
liquids.
29.
CAUTION: Remove the power cord before change FUSE and replace only with
the same ratings and type of FUSE.
30.
Observe local occupational health and safety requirements and guidelines for
manual materials handling.
31.
Do not attempt to move a equipment by yourself; at least two people are needed
to move a equipment.
32.
Use only the power cords and power supply units provided with your equipment.
The equipment might have one or more power cords.
33.
Operation of the device without regulatory approval is illegal.
34.
CAUTION: Disposal of a battery (or battery pack) into fire or a hot oven, or
mechanically crushing or cutting of a battery (or battery pack), that can result in
an EXPLOSION; leaving a battery (or battery pack) in an extremely high tem-
perature surrounding environment that can result in an EXPLOSION or the leak-
age of flammable liquid or gas; a battery(or battery pack) subjected to extremely
low air pressure that may result in an EXPLOSION or the leakage of flammable
liquid or gas. Discard used batteries according to the manufacturer's instruc-
tions.
35.
CAUTION: To disconnect power, remove all power cords.
36.
CAUTION: If the user does not follow the user manual to use the equipment, it
will have risk to cause the bottom side opening of the equipment.
37.
CAUTION: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equip-
ment.
Contact information:
Advantech Co., Ltd.
Website: www.advantech.com.tw
Address: No.1, Alley 20, Lane 26, Rueiguang Road Neihu District, Taipei, Taiwan
114, R.O.C.
TEL: +886-2-27927818
1.
请仔细阅读此安全操作说明。
2.
请妥善保存此用户手册供日后参考。
3.
用湿抹布清洗设备前,请确认拔除电源线。请勿使用液体或去污喷雾剂清洗设
备。
4.
对于使用电源线的设备,设备周围必须有容易连接的电源插座。
5.
请不要在潮湿环境中使用设备。
6.
请在安装前确保设备放置在可靠的平面上,意外摔落可能会导致设备损坏。
7.
请不要将设备放置在超出建议温度范围的环境,即不要低于 0° C(32°F) 或高
于 40°C (122°F), 否则可能会造成设备损坏。
8.
设备机壳的开孔适用于空气对流,为了防止设备过热。请勿覆盖开孔。
9.
当您连接设备到电源插座前,请确认电源插座的电压符合要求和接地连接。请确
认电源线连接到有接地设备的插座。
10.
请将电源线布置在人们不易绊倒的位置,请勿在电源在线覆盖任何杂物。
11.
请注意设备上所有的警告和注意标语。
CLASS I LASER PRODUCT
KLASS I LASER PRODUKT
v
IPC-7120S User Manual/ 用户手册

Advertisement

Table of Contents
loading

Table of Contents