Installing Door Frame Heater Plug On Freezer Models; The Floor Heating On Freezer Models; How To Mount The Lamp - Porkka C 940 Installation And Operation Manual

Fasten the cover plate of the machinery unit with white-heel pull
rivets of Ø 3.2 mm.
INSTALLING DOOR FRAME HEATER PLUG ON FREEZER
MODELS
On a freezer unit there will be a short cable with plug fi tted, this
should be inserted in to the corresponding socket next to the
door frame. A small amount of silicon can be used to seal the
socket from any moisture penetration. Install the
protector around the plug see the pic.10.
Pic. 10. Door frame heater plug protector

THE FLOOR HEATING ON FREEZER MODELS

The coupling of the freezer's fl oor heating (optional) is electric
installation subject to licence and have to be done by an
authorized electrician. National orders concerning electric
installation are to be observed. Floor heating cables must not
use the fuse that is common to the machine unit or other pieces
of electrical equipment.

HOW TO MOUNT THE LAMP

Remove the stopper screw (1) of the lamp globe and turn the
globe (2) slightly so that it comes off the holders. Inside the
globe there are a 60W light bulb (3) and two mounting screws
3
(4).
Remove the refl ecting plate (5) and connect the wire bayonet
catches (6) together. Put the frame back with mounting screws
(4). Do not put the extra wire inside the evaporator casing.
Fasten the refl ecting plate (5) and screw the light bulb (3) back.
Put the protective globe back in place and turn it slightly when
you will be able to screw the stopper screw (1) back in place.
4
3
1
5
2
4
6
Picture 11a. Parts of the lamp Picture 11b. Mounting of the lamp
5