To Mount The Control Panel; Changing The Hinging Of The Door - Porkka C 940 Installation And Operation Manual

Pic. serie 12.The lock counter part assembly
Pic. serie 13. Assembly of the hinges

TO MOUNT THE CONTROL PANEL

1
Remove the control panel from shipping position attached to
side wall (1). Attach panel in operational position (2).

CHANGING THE HINGING OF THE DOOR

The frame has pre-fabricated holes for all the necessary screws
to allow the change the hinging of the door afterwards. After the
assembly work please cover the unnecessary holes with the
white plugs (packed into the accessory kit).
Installation of the lock counterpart (Pic. serie 12):
Loosen the screw A. Please do not remove it. Detatch the pin
assembly from the body. During reassembly, please fi rst adjust
the depth of the pin assembly before tightening the screw to
ensure the proper function of the Jumbo-lock. Dismount the
body of the lock's counter part by removing the screws
B (4 pcs). During reassembly, before tightening the screws,
please adjust the siting of the counterpart. Dismount the base
by removing the screws C. To reassemble in reverse order.
Installation of the hinges (Pic. serie13):
Open the door completely (180°) and place a support under the
front corner to avoid any damages.
Remove the hinge cover plates D (2 pcs/hinge) by pushing
gentle with a screw driver. There are screws E (4 pcs/hinge)
under the covers. By removing them you dismount the hinges
from the frame.
DO NOT REMOVE THE HINGES FROM THE DOOR
LEAF
To reassemble in reverse order. Before tightening the screws
E, ensure the doorleaf is properly located in the middle of the
frame.
ALWAYS CHECK SATISFACTORY FUNCTION OF THE
EMERGENCY INNER RELEASE.
5 6
2