Download
Share
Print this page
SIIG CE-H21U11-S1 Installation Manual
  1. Manuals
  2. Brands
  3. SIIG Manuals
  4. Extender
  5. CE-H21U11-S1
  6. Installation manual

SIIG CE-H21U11-S1 Installation Manual

Hdmi wireless extender
Hide thumbs

Advertisement

Quick Links

Download this manual
Introduction
The HDMI Wireless Extender provides an easy way to
extend HDMI signals wirelessly up to 80 meters.
Features and Benefits
•
Sends video and audio from your HDMI source to
TV/display wirelessly in 1080p quality
•
Transmits content up to 80 meters LOS (Line of
Sight) with no latency
•
Supports 2.4GHz frequency with channel hopping
– channel automatically changes when an
interference is detected with other RF sources
•
IR extender to control HDMI source device from the
remote HDMI display end
•
Complete kit with a Transmitter (TX) and Receiver
(RX)
•
HDMI output on Transmitter (TX) for a local TV/
display next to the source device
•
Wall mountable
•
LED status indicators for Power and Wireless
connection
System Requirements
•
PC or A/V devices with an available HDMI output port
•
HDMI display
04-0909A
HDMI Wireless Extender
Installation Guide
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the CE-H21U11-S1 and is the answer not in the manual?

Questions and answers

Related Manuals for SIIG CE-H21U11-S1

Summary of Contents for SIIG CE-H21U11-S1

  • Page 1 HDMI Wireless Extender Installation Guide Introduction The HDMI Wireless Extender provides an easy way to extend HDMI signals wirelessly up to 80 meters. Features and Benefits • Sends video and audio from your HDMI source to TV/display wirelessly in 1080p quality •...

  • Page 2: Package Contents

    Package Contents • HDMI Wireless Extender (Transmitter x1, Receiver • HDMI cables (2) • Power adapters (5V/2A for Transmitter, 5V/1A for Receiver) • IR blaster cable • Screws for wall mount (4) • Installation guide Application ODD Player HDMI Display IR Blaster Transmitter IR Blaster...
  • Page 3 Layout Antenna Transmitter Power Button Power Jack Power LED Pairing Button Wireless LED HDMI Out IR Blaster HDMI In Figure 2: Transmitter Layout • Wireless LED: Red when the connection is established; flashing when searching for signal or disconnected • Power LED: Red when the power adapter is connected;...
  • Page 4 Receiver Antenna Power Button Power Jack Power LED Pairing Button Wireless LED HDMI Out Figure 3: Receiver Layout • Wireless LED: Red when the connection is established; flashing when searching for signal or disconnected • Power LED: Red when the power adapter is connected;...

  • Page 5: Dc Power Jack

    Point the IR Blaster towards the HDMI source device's IR receiver 1. IR Signal 2. Ground Figure 4 Note: IR cables can be found in the market. However, cables longer than 6ft may not work. DC Power Jack Refer to the table below for the specifications of the power adapter.

  • Page 6: Hardware Installation

    Hardware Installation Power off the displays, AV device and the extenders. Setup Transmitter: Connect your HDMI source to the HDMI In using the included HDMI cable and connect your HDMI display* to the HDMI Out using an HDMI cable (cable not included). *Note: Connecting this HDMI display is optional.
  • Page 7 Mount the Extenders on the Wall Drill the pilot holes. Insert the included screws into the wall. Leave approximately 1/8 inch for mounting the transmitter or receiver. Place the extender's mounting holes over the protruding screws and slide it down into position. Figure 5 Q1: The Power LED doesn't light up.
  • Page 8 • Verify the Power LEDs and Wireless LEDs: If the wireless LEDs are flashing red: Move the transmitter closer to the receiver. The transmission range between the transmitter and the receiver should not exceed 80 meters (LOS-line of sight) transmission distance. If the wireless LEDs are off: •...
  • Page 9 Blank Page...
  • Page 10 Blank Page...

  • Page 11: Technical Support And Warranty

    (2) years from the date of purchase of the product. SIIG will, at our discretion, repair or replace (with an identical product or product having similar features and functionality) the product if defective in materials or workmanship.
  • Page 12 Fremont, CA 94538-3152, USA Phone: 510-657-8688 HDMI Wireless Extender is a trademark of SIIG, Inc. SIIG and the SIIG logo are registered trademarks of SIIG, Inc. Microsoft and Windows are registered trademarks of Microsoft Corporation. All other names used in this publication are for identification only and may be trademarks of their respective owners.