Replacing The Fuse; Propeller Change - Honda BF8D Manual

11/09/05 18:17:20 32ZY0620_127
Replacing the Fuse (Electric starter
type and 6A charge coil type)
SPARE 20A FUSE
20A FUSE FUSE CASE LID
If the fuse blows, running the engine
will not charge the battery. Before
replacing the fuse, check the current
ratings of the electrical accessories
and ensure that there are no
abnormalities.
〈 How to replace the fuse
1. Stop the engine.
2. Remove the engine cover.
3. Remove the fuse case lid and pull
the blown fuse out of the clip with
your finger.
4. Push a new fuse into the clips.
BLOWN FUSE
〈
Designated fuse
Never use a fuse with a
different rating from that
specified. Serious damage to
the electrical system or a fire
〉 may result.
If the fuse is blown, check the
cause, then replace the fuse with a
spare fuse of the same rated
capacity. Unless the cause is found,
the fuse may blow again.

Propeller Change

TOWARD
GEAR CASE
THRUST WASHER
〉 20A
If the propeller is damaged by
striking a rock, or other obstacle,
replace the propeller as follows.
1. Remove the cotter pin then remove
the 10 mm castle nut, 10 mm plain
washer, propeller and thrust
washer.
MAINTENANCE
PROPELLER
PLAIN
WASHER
CASTLE
NUT
COTTER PIN
127