Replacing The Fuse - Honda BF4A Operation And Maintenance Ma

MAINTENANCE
<Tank Filter Cleaning>
5 mm SCREWS
CONNECTOR
GASKET
FUEL TANK FILTER
FUEL TANK FILTER JOINT
(Fuel Line Connector)
1. Remove the four 5 mm screws
using a flat screwdriver, then
remove the fuel line connector and
fuel tank filter from the tank.
2. Clean the filter in nonflammable
solvent. Inspect the fuel tank filter
and the connector gasket. Replace
them if damaged.
3. Reinstall the filter and line
connector in the fuel tank. Tighten
the four 5 mm screws securely.
86

Replacing the Fuse

(Equipped type)
The fuse is attached to the battery charge cable.
FUSE
FUSE CASE LID
If the fuse blows, running the engine
will not charge the battery. Before
replacing the fuse, check the current
ratings of the electrical accessories
and ensure that there are no
abnormalities.
<How to replace the fuse>
1. Stop the engine.
2. Remove the fuse case lid and pull
the blown fuse out of the clip with
your finger.
3. Push the spare fuse into the clips.
SPARE FUSE
<Designated fuse> 15A
Never use a fuse with a different
rating from that specified. Serious
damage to the electrical system or a
fire may result.
If the fuse is blown, check the cause,
then replace the fuse with a spare fuse
of the same rated capacity. Unless the
cause is found, the fuse may blow
again.
BLOWN FUSE