Table of Contents
Advertisement
Mounting the instrument Two M4 threaded screws are needed for mounting the
Mounting the front cover
back
12
instrument (these are not accessories). The type of the
screws depends on the wall-material, while the dimensions
depend on the wall-thickness. The minimum screw-length
should be the wall-thickness + 10 mm.
Secure the screws against getting loose. For this purpose
you may use spring lock or serrated lock washers.
Depending on the material of the wall, and in order to
ensure the most practicable mounting method, it is not
mandatory, of course, to use the above-described threaded
joints. Depending on the situation, special screw types for
wood or for metal sheets can also be used, or the joint can
be riveted too.
1. Put back the front cover of the instrument, taking care that
the sealing should get to its place. There should be no gap,
between the housing and the front cover.
2. Tighten the front cover by turning the screws in clockwise
direction. Tighten the screws so much that ensures the
desired sealing.
The mounting procedure is ready.
DT7000
20171206-V1
Advertisement
Table of Contents
