ViewSonic PJ1158 User Manual page 90

Schedule Settings
Schedule settings can be configured from a web browser.
Example: If the IP address of the projector is set to 192.168.1.10:
1) Enter [https://192.168.1.10] into the address bar of the web browser.
2) Enter the Admnstrator ID and Password and clck [Logon].
3) C lck [Schedule Settings] on the man menu and select the requred schedule
tem.
4) Clck the [Enable] check box to enable schedulng.
5) Enter the Date (Month/Day) for specific date scheduling.
6) C lck [Add] and set the hour, command and parameters and clck [Add This
Schedule] when you want to add a command.
7) Clck the [Delete] button when you want to delete a schedule.
8) Clck the [Apply] button to save the settngs.
There are three types of schedulng.
1) Daily: Perform the specified operation at a specified time every day.
2) Sunday ~ Saturday: Perform the specified operation at the specified time on a
specified day of the week.
3) Specific Date: Perform the specified operation on the specified date and time.
NOTE
• In Standby mode the power indicator will flash green for approx. 3
seconds when at least 1 "Power ON" schedule s saved.
• When the schedule functon s used, the power cord must be connected to
the projector and the outlet and the power switch must be turned on, [ | ]. The
schedule functon does not work when the power swtch s turned off, [¡] or
the breaker n a room s trpped. The power ndcator wll lghts orange or green
when the projector gets s recevng the power.
ViewSonic PJ1158
Controlling the Projector via Scheduling
85