Table of Contents
Advertisement
NETWORK Menu
Consult wth your network admnstrator before connectng to an
exstng access pont on your network. Incorrect network settngs
on ths projector may cause trouble on the network.
Select "NETWORK" from the man menu to access the followng
functons.
Select an item using the ▲/▼ cursor buttons on the projector or
remote control, and press the ► cursor button on the projector or
remote control, or ENTER button on the remote control to execute
the tem. Then perform t accordng to the followng table.
NOTE • The factory default settng for DHCP s "TURN ON". There s no need to set
up [DHCP], [IP ADDRESS], [SUBNET MASK] or [DEFAULT GATEWAY] if your network
has DHCP enabled.
• If you are not utlzng SNTP, then you must set the DATE AND TIME durng the ntal
nstallaton. Please refer to the tem DATE AND TIME on the followng lst.
Item
DHCP (Dynamic
Host Configura-
tion Protocol)
IP ADDRESS
SUBNET MASK
DEFAULT GATE-
WAY
(contnued on next page)
ViewSonic
DHCP TURN ON/TURN OFF:
Use the ▲/▼ buttons to turn DHCP on/off
TURN ON ó TURN OFF
Select TURN OFF when the network does not have DHCP en-
abled.
Enterng the IP ADDRESS :
Use the ▲/▼/◄/► buttons to enter the IP
ADDRESS. Ths functon can only be used
when DHCP s set to "TURN OFF".
• The IP ADDRESS is the number that identifies this projector on
the network. You cannot have two devces wth the same IP AD-
DRESS on the same network.
Enterng the SUBNET MASK :
Use the ▲/▼/◄/► buttons to enter the
same SUBNET MASK used by your PC.
Ths functon can only be used when DHCP
s set to "TURN OFF".
Enterng the DEFAULT GATEWAY :
Use the ▲/▼/◄/► buttons to enter the DE-
FAULT GATEWAY (a node on a computor net-
work that serves as an access pont to another
network) address.Ths functon can only be
used when DHCP s set to "TURN OFF".
PJ1158
Description
NETWORK Menu
192. 168.
1.
254
IP ADDRESS
255. 255.
255.
0
SUBNET MASK
0.
0.
0.
0
DEFAULT GATEWAY
53
Advertisement
Table of Contents
