Table of Contents
Advertisement
IMAGE Menu
From the IMAGE menu, tems shown n the table below
can be performed.
Select an item using the ▲/▼ cursor buttons on the
projector or remote control, and press the ► cursor button
on the projector or remote control, or ENTER button on
the remote control to execute the tem. Then perform t
accordng to the followng table.
Item
ASPECT
OVER SCAN
V POSITION
H POSITION
(contnued on next page)
ViewSonic
Using the ▲/▼ buttons switches the mode for aspect ratio.
For an RGB signal
NORMAL ó 4:3 ó 16:9 ó SMALL
For an M1-D signal
NORMAL ó 4:3 ó 16:9 ó 14:9 ó SMALL
For a Video signal, S-video signal or Component video signal
4:3 ó 16:9 ó 14:9 ó SMALL
For no signal
4:3 (fixed)
• The NORMAL mode keeps the orgnal aspect rato of the sgnal.
Using the ▲/▼ buttons adjusts the over-scan ratio.
Large (It reduces pcture) ó Small (It magnifies picture)
• This item can be selected only for a video, s-video and component signal.
• When ths adjustment s too large, certan degradaton may appear
at the frame area of the pcture. In such a case, please adjust small.
Using the ▲/▼ buttons adjusts the vertical position.
Up ó Down
• Over-adjusting the vertical position may cause noise to appear
on the screen. If ths occurs please reset the vertcal poston to the
default settng. Pressng the RESET button when the V POSITION
s selected wll reset the V POSITION to the default settng.
• When this function is performed on a video signal, s-video signal,
or component vdeo sgnal of 525 (480) or 625 (576), the range of
ths adjustment depends on the OVER SCAN settng. It s not pos-
sble to adjust when the OVER SCAN s set to 10.
Using the ▲/▼ buttons adjusts the horizontal position.
Left ó Rght
• Over-adjusting the horizontal position may cause noise to appear
on the screen. If ths occurs please reset the horzontal poston to the
default settng. Pressng the RESET button when the H POSITION s
selected wll reset the H POSITION to the default settng.
• When this function is performed on a video signal, s-video signal,
or component vdeo sgnal of 525 (480) or 625 (576), the range of
ths adjustment depends on the OVER SCAN settng. It s not pos-
sble to adjust when the OVER SCAN s set to 10.
PJ1158
Description
IMAGE Menu
29
Advertisement
Table of Contents
