Extended Menu - Televes T.OX Series User Manual

Hide thumbs Also See for T.OX Series:
Table of Contents

Advertisement

The allowed values for the main audio carrier level
relative to that of the video are: -12dB and -16dB.
After pressing the parameter selection key
press) the following sub-menu allows to change
the audio sub-carrier level (5.74MHz) relative to
that of the video (RelSubC).
The range of values that are allowed for selection
are: -18dB, -20dB, -22dB, -24dB.
e. Mode Menu
Pressing
accesses the following menu. In this
menu, it is possible to con figure the modulation
output mode, audio mode
parameters.
(*) Only in the case where the main audio carrier is at
5.5MHz.
ODO
AMODE
o Audio:
Audio Mode:
o
Mono
oTest OFF
TestMode OFF
Initially pressing the parameter selection key (short
press)
allows selection of a desired modulator;
then, press
or
to change the modulator that
will be con figured.
Short pressing the parameter selection key
accesses the function mode menu (Audio Mode).
Pressing
mono (for separation between 5.5 MHz carriers).
(short
Short pressing the parameter selection key
accesses the function mode sub-menu (TestMode).
Using keys
(ON) and deactivated (OFF).
In function mode with test pattern deactivated,
the output signal is modulated with external audio
and video (A/V in). This will be normal functioning
mode.
In function mode with test
salida está formada por una señal de prueba
generada internamente por el modulador y
formada por dos barras verticales sobre fondo
negro y un tono de audio.
and test pattern mode
(*)
AMODUS
Audio Modus:
Mono
TestModusOFF
and
selects between stereo, dual or
and
selects between activated
pattern, la señal de
CONFIG
Dir CDC: 001

5.2. Extended Menu

To access extended menus, hold down the
for more than three seconds. Menu selection, as
well as modi fication of selected values and saving
changes, are made in the same manner as in the
main menu.
Once in extended mode, you can move through
each menu by short pressing .
a. Configuration Menu
Allows selection of the unit's address for
communicating with the Header Control.
CONFIG
Adr CDC: 001
The unit's address is programmed number by
number, moving to the next digit by pressing
(short), and modifying its value by pressing
. The allowed values are between 1 and 254 (0
and 255 values being reserved for other purposes).
17
key
EN
AUFBAU
Adr CDC: 00
or

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Twin modulator5806

Table of Contents