How To Use The Product; Main Menu - Televes T.OX Series User Manual

Twin Modulator
5. - Instructions for use
The unit sends its con figured parameters
(frequencies/output channels, output levels, audio
and video confi guration, FW version,...) to the
programmer when they are connected each other.
Upon initiating the process, the SW version of the
programmer will be displayed for a few seconds
with the following screen:
PCT firmware
version
------------
V: X.XX
Next, the programmer's display will show the
loaded FW version for a few
ers. FW. Vers. FW.
x.xx Vx.xx
ers. Boot Vers. Boot
:x.xx V:x.xx
After this, the main menu is displayed.

5.1. Main Menu

From here on, scroll down to see the different
submenus by pressing the key
Channel Table Menu, Video Menu, Audio Menu and
Audio Mode Menu.
Note: If you wish to change the menu language , the
To switch between A and B modules of the
TWIN unit, keep pressed the key
seconds:
indication stars to flash in the upper left corner
of the display.Then use keys
Vers. FW.
desired module.
Vx.xx
Vers. Boot
V:x.xx
: Output Menu,
"Language" menu should be accessed before
con figuring the device. This is done by holding
down the key in order to access the Extended
menu, pressing the key three times and then
pressing or to select language. Finally,
hold down the key to record changes. For
more information, see "Extended Menu =>
".
Select Language" section
until the A/B
and to select de
a. Output Menu
Allows to select the module to be con figured and
its output channel, both in channel mode and in
frequency mode, and indicates the output level.
The way it is displayed will depend on how the
module has been programmed since its last con-
figuration (frequency mode or channel mode).
If the device is in channel mode, then this
menu displays the number and frequency of the
output channel's video carrier (which varies upon
changing the channel); it also displays digits
(00-99) allowing control of the corresponding
modulator's output level via the programmer. To
select one of the modulators (A or B) of the TWIN
unit, press the key once, then the A/B indication
will flash. Next, use keys
B selection.
To change the output channel of the chosen
modulator, move through the menu by pressing
the parameter selection key
value stars to flash. Then use keys
change it.
For example, if the selected channel is C21 of the
CCIR UHF table:
ASALIDA AOUTPUT
Canal: C21 Channel: C21
(471.25 MHz) (471.25 MHz)
Nivel: 99 Level:
ASALIDA AOUTPUT
Frecuencia: Frequency:
474.00 MHz 474.00 MHz
Nivel: 99 Level:
14
or to make the A or
until the channel
and to
AAUSGANG
Kanal:
(471.25 M
99 Pegel:
AAUSGANG
Frequenz:
474.00 MH
99 Pegel: