Table of Contents
Advertisement
05/08 AWB2528-1611en
Settings
3
Setting and commissioning the
device
You can display and modify the station address (node ID),
baud rate, backlight and contrast via the MFD80 display.
Press the DEL and ALT buttons simultaneously to call up the
Setup menu.
NodeID : 2
Baud rate:125
Backlight:100%
Contrast: 100%
Figure 24:
Í
Use the
and
Press OK to then switch to Entry mode. Entry mode enables
you to change the setting using the
the OK button again stores the actual value.
Ú
Pressing the
ware version of the device to be displayed.
h
The device is provided with an automatic baud rate detec-
tion feature. A setting for this is therefore not normally
required. If the MFD4-CO is the only station on the bus,
and if the master does not support automatic baud rate
detection, the baud rate can be set via the display.
Setup menu
Ú
buttons to select the required parameters.
ú
button in the last line causes the current soft-
í
and
buttons. Pressing
25
Hide quick links:
Advertisement
Table of Contents
