Table of Contents
Advertisement
OIT500-F113-B12-CB3
Commissioning
5.2.3
Sensor Menu
Figure 5.5
Load settings
Save settings
Change network
settings
Make firmware update
Show device version
Sync with sensor
Adjust sensor
calibration
Table 5.3
Note!
Firmware Update
Once you have upgraded the firmware and Update complete is displayed, restart the sensor.
38
Sensor menu
Loads the saved settings from the sensor
Saves the settings to the sensor
Change the network settings. The settings window allows you to
set the IP address, subnet mask, gateway address, and DHCP
Performs firmware updates. This command should be used by
experienced users only
Displays the device version
Synchronization with the sensor
Adjust the sensor calibration
Sensor menu
Advertisement
Table of Contents
