Parameterization - Pepperl+Fuchs OIT500-F113-B12-CB3 Manual

OIT500-F113-B12-CB3

Parameterization

4 Parameterization
The factory default parameters are stored in the OIT memory. You can adjust the parameters
using the Vision Configurator software or the control panel.
Configuration Parameters
Configuration ID Parameter ID
System EnableResultPort
UDP
PortOut
PortOutUdp
SensorName
ImageTransferActive
ImageTransfer
BadImageTransfer
Camera ExposureTime
Gain
StartLive
StopLive
CheckImages
DisplayPause
Command TriggerStart
GetLastImg
GetErrImg
SetDefaultParams
ResetCounters
Control panel EdgeMode
TriggerReleaseOption 0,1
Value
0,1
0,1
1 – 65,536
1 – 65,536
String
0,1 (default: 0)
ALL_IMG
ERROR_IMG
GOOD_IMG
INSPECT_IMAGE
INSPECT_IMAGE_2
10 – 20,000 (default: 1500)
0 – 255 (default: 0)
1
1
0,1
100 – 10,000
1
1
1
1
1
TRIGGER_EDGE_POS
TRIGGER_EDGE_NEG
Description
Activates TCP/IP result output
Activates UDP result output
TCP port
UDP port
Name of the sensor
Activates image transfer if the
sensor is connected. 0 for
RunTime, 1 to set up (with image
display)
Specify which images should be
transferred to the end device
Specify which image should be sent
to the end device if the sensor has
transferred two images in the case
of a fault
Exposure time in s
Image gain
Starts continuous image transfer
mode
Stops continuous image transfer
mode
If this is set, the sensor also starts
code sheet detection in continuous
image transfer mode
Delay time before the next image
capture can be started, in ms
Trigger start
Loads the last captured image
Loads the next error image in a
series of up to ten images
Loads the default parameters
Sets all internal counters to 0
Sets the trigger activation according
to the rising or falling edge
If this is set, the sensor waits for an
input signal when activating the
trigger. If this option is disabled, the
input signal of the trigger is ignored
33