The following options for signal visualization are available (Figure 6.11):
-
The time scale (24):
o If set to auto, the time scale is automatically set;
o If set to manual, the user can manually change the
o The time scale value is always shown (26).
-
The Signal display window shows the filtered signals by default. The
filter function is designed by using the bandpass filter (0.1-40Hz).
However, this function can be disabled and the raw signals can be
visualized by clicking the filter off button (27). To observe the filtered
data again, click the same button again. Note: the signals are filtered
for visualization purposes only. When recording or streaming the
signals, the streamer stores and transmits the raw (non-filtered)
data regardless of the filtering option selected;
-
The amplitude scale is also by default set to auto (28). In this way, the
scale is optimized to visualizing all the signals from each of the
channels. Alternatively, the user can set the scale to manual (28) and
adjust it by pressing + or - sign (29). The amplitude scale value is
always visible, while the Signal display window is on (30); For optimal
24
Figure 6.11 The Signal display window
corresponding time scale by clicking + to increase or - to
decrease the time scale (25) – this controls the time window
being displayed;
SMARTING User Manual – Release 11/03/2019