Table of Contents
Advertisement
BEFORE YOU BEGIN
0.6
m
(2
)
ft
tRAINING AREA
8
0.3
(1
)
m
ft
WARNING!
Our equipment is heavy, use care and additional help if necessary when moving.
Failure to follow these instructions could result in injury.
0.6
0.6
m
m
LOCATION OF THE UNIT
(2
)
(2
)
ft
ft
Ensure that there is a clear zone behind the treadmill that is at least the width of the treadmill and at least 2 meters (at
least 79") long. This clear zone is important to reduce the risk of serious injury were a user to fall off the back edge of
the treadmill. This zone must be clear of any obstruction and provide the user a clear exit path from the machine.
For ease of access, there should be an accessible space on both sides of the treadmill of at least 24" (0.6 meters) to allow a
user access to the treadmill from either side. Do not place the treadmill in any area that will block any vent or air openings.
fREE AREA
Locate the equipment away from direct sunlight. The intense UV light can cause discoloration on the plastics. Locate the
equipment in an area with cool temperatures and low humidity. The treadmill should not be located outdoors, near water,
2
(79")
or in any environment that is not temperature and humidity controlled (such as in a garage, covered patio, etc.).
m
LEVELING THE EQUIPMENT
Install equipment on a stable and level floor. It is extremely important that the levelers are
correctly adjusted for proper operation. Turn leveling foot clockwise to lower and counter-
clockwise to raise unit. Adjust each side as needed until the equipment is level. An unbalanced
unit may cause belt misalignment or other issues. Use of a level is recommended.
SERVICE CASTER
The Performance Plus (optional Performance) has built-in caster wheels located near the end caps. To unlock
the caster wheels, use the provided allen wrench (located in the cable wrap holder under the front cover). If you
need extra clearance when moving the treadmill, the rear levelers must be raised all the way up into the frame.
IMPORTANT:
Once the treadmill is moved into position, use the allen wrench to rotate the caster bolt
into the locked
position to prevent the treadmill from moving during use.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the PERFORMANCE and is the answer not in the manual?
Questions and answers
How do I turn off the tread sense so I can do sprints with longer rests in between