Advertisement
Table of Contents
Advertisement
Table of Contents
Related Manuals for Matrix PERFORMANCE
Summary of Contents for Matrix PERFORMANCE
-
Page 3: Important Precautions
IMPORTANT PRECAUTIONS SAVE THESE INSTRUCTIONS DANGER! When using a treadmill, basic precautions should always be followed, including the TO REDUCE THE RISK OF ELECTRICAL SHOCK: following: To ensure your safety and protect the equipment, read all instructions before operating. It is the responsibility of the owner to ensure that all users of Always unplug the equipment from the electrical outlet immediately after using, this equipment are adequately informed of all warnings and precautions. -
Page 4: Power Requirements
ELECTRICAL REQUIREMENTS harmful interference in a residential installation. This equipment generates, uses and can radiate radio For your safety and to ensure good treadmill performance, frequency energy and, if not installed and used in ADDITIONAL ELECTRICAL INFO the ground on this circuit must be non-looped (isolated). -
Page 5: Important Notes
ASSEMBLY UNPACKING TOOLS REQUIRED: Unpack the equipment where you will be using it. Place the carton F 8mm T-Wrench on a level flat surface. It is recommended that you place a protective F 5mm Allen Wrench covering on your floor. Never open box when it is on its side. F 6mm Allen Wrench F Phillips Screwdriver IMPORTANT NOTES... - Page 6 Torque Value Hardware 40 Nm / 29 ft-lb Bolt Bushing Performance only Hardware Hardware Torque Value Torque Value 40 Nm / 29 ft-lb 40 Nm / 29 ft-lb Bolt Bolt Flat Washer Bushing Performance Pre-installed bolt locations Performance Plus bolt locations...
- Page 7 Torque Value Torque Value Hardware Hardware 40 Nm / 29 ft-lb 40 Nm / 29 ft-lb Bolt Bolt MCB Communication Flat Washer Screw Extension Power Wire Emergency Stop TV Power Console Connect Wires Ethernet Coax Ground Wire ASSEMBLY COMPLETE Hardware Torque Value 10 Nm / 7 ft-lb Bolt...
-
Page 8: Before You Begin
Use of a level is recommended. SERVICE CASTER The Performance Plus (optional Performance) has built-in caster wheels located near the end caps. To unlock the caster wheels, use the provided allen wrench (located in the cable wrap holder under the front cover). If you need extra clearance when moving the treadmill, the rear levelers must be raised all the way up into the frame. -
Page 9: Product Specifications
Electrical Requirements 20 A dedicated circuit required-non-looped-grounded * Ensure a minimum clearance width of 0.6 meters (24”) for access to and passage around MATRIX equipment. Please note, 0.91 meters (36”) is the ADA recommended clearance width for individuals in wheelchairs. -
Page 10: Intended Use
INTENDED USE CAUTION! RISK OF INJURY TO PERSONS • Treadmill is intended for walking, jogging, or running exercises only. While you are preparing to use the treadmill, do not stand on the belt. Place your feet on the • Always wear athletic shoes while using this equipment. side rails before starting the treadmill. -
Page 11: Maintenance
5) Ensure that any person(s) making adjustments or performing maintenance MONTHLY WARNING: Do not plug the treadmill in until the motor cover has or repair of any kind is qualified to do so. MATRIX dealers will provide service been reinstalled. and maintenance training at our corporate facility upon request. - Page 12 © 2019 Johnson Health Tech Rev 1.0 A...
Need help?
Do you have a question about the PERFORMANCE and is the answer not in the manual?
Questions and answers
How do I turn off the tread sense so I can do sprints with longer rests in between