Bosch+Sohn BoSo Medicus Smart User Instructions page 56

Measuring your blood pressure
If the ambient temperature changes
significantly, leave the device about an
hour to adapt to the new ambient tempe-
rature before using it.
The performance of the device can be
EN
affected by excessive temperature, humi-
dity or altitude.
¬ Now take the rubber ball into your
right hand and inflate the cuff to
approx. 180 mmHg. A triple signal tone
occurs. The rising cuff pressure is
shown on the digital display. In case
the pressure in the cuff is not high
enough, the symbol
the measurement. Please inflate the
cuff by approx. 40 mmHg more. This
procedure may be repeated unil the
56
At the following measurement the neces-
sary inflation pressure is adjusted by the
memomatic function, i.e. inflation pres-
sure = SYSTOLIC of last measurement ta-
ken +40 mmHg). Please inflate until the tri-
ple signal tone indicated the correct
pressure.
Important: The additional increase in the
cuff pressure can cause faulty readings. If
appears during this occurs, repeat the measurement after
a 2 minute interval and this time inflate
straight to above your upper (systolic)
blood pressure value.
pressure in the cuff is higher than the
systolic blood pressure (symbol
appears and the triple signal tone
occurs).
dis-