Product Description; Installation And Connection - Oase biOrb HALO Series Operating Instructions Manual

PRODUCT DESCRIPTION

• Check that the delivery scope is correct, complete
and undamaged.
 A biOrb HALO
1 Operating instructions biOrb HALO
2 Cover with cover ring and product-specific lighting
unit
3 Air column
4 Air hose with integrated non-return valve
5 Aerator pump with connection cable
6 Plug-in transformer
7 Ceramic substrate
− Quantity is product-specific
8 Bag with Water Conditioner and/or Biological
Booster
9 Filter unit
W A R N I N G
Danger of suffocation.
Keep plastic bags and small parts out of reach of babies
and young children.
Intended use
Exclusively use the biOrb HALO as follows:
• As an aquarium.
• Only operate with water at a water temperature of
+4 °C to +35 °C.
• Ensure that the water temperature is suitable for
the type of fish.
The supplied components may only be used for the bi-
Orb products as specified in the following:
• The aerator pump: For aeration and supplying oxy-
gen to the aquarium.
• The lighting unit: For lighting the aquarium.
• The plug-in transformer: For connecting the aerator
pump and lighting unit to the mains.
• Operation under observance of the technical data.
The following lighting units are approved for lighting
the biOrb HALO aquarium:
• biOrb HALO 30/60 LED
• biOrb HALO 15/30/60 MCR LED
Function description
Aquarium with LED lighting, filter unit and external
aerator pump for circulating the water.
The light colour depends on the lighting unit used and
can be white, coloured, continuous or automatically
changing.
All the lighting units can be programmed with the ex-
ception of biOrb HALO 30/60 LED.
biOrb HALO 30/60 LED
• Daylight: White LEDs are continuously lit
biOrb HALO 30/60 MCR LED
• Four modes for automatic changes between differ-
ent daylight and moonlight phases for a period of
24 hours.
• The colour and dimming variants are controlled via
the remote control
biOrb HALO 15 MCR LED
• White light or individually set coloured light, which
can be set and dimmed by remote control.

INSTALLATION AND CONNECTION

Setting up the aquarium
How to proceed:
• Carefully unpack the acrylic aquarium.
• Do not expose to direct sunlight.
• Only set up in closed rooms.
• Do not move the aquarium when it is filled.
• Do not place on or near electrical devices.
• Do not place on or near heat sources.
• Operation under observance of the technical data.
Fitting the filter unit
How to proceed:
• Remove the packaging from the filter medium.
 B
1. Open the lid.
2. Remove the evaporation tray.
3. Release the air column from the filter housing by a
quarter turn counterclockwise (bayonet closure)
and lift out.
4. Place the air column onto the filter cartridge and
fasten the air column by a quarter turn counter-
clockwise.
5. Insert the air column into the aquarium and fasten
it to the filter housing by a quarter turn clockwise.
Using the ceramic substrate
N O T E
Remove the packaging from the filter medium. Thor-
oughly rinse the ceramic substrate with warm tap wa-
ter before using for the first time to remove any soil-
ing. (→ Replacing the filter cartridge)
- EN -
19