Product Description; Accessing The Unit; Installation And Connection - Oase FiltoSmart 60 Operating Instructions Manual

PRODUCT DESCRIPTION

Scope of delivery
 A FiltoSmart 60
1 Operating manual for FiltoSmart 60
2 Unit head
3 Blind plug
4 Hose connector, inlet (IN)
5 Container, filled with filter medium
6 Slide closure
7 Hose connector, outlet
8 Bag with 4 feet
9 Ceramic substrate
(120 g bag)
10 Hose
11 Flow-out pipe
12 Suction pipe
 B Connection set
1 Suction cup
2 Terminal
3 Hose adapter
4 Angle piece
5 Union nut
6 Suction basket
7 Water distributor
8 Cover cap
Intended use
Only use the product described in this manual as
follows:
• Water filtering and recirculation
• For operation with freshwater or saltwater.
• Operate in accordance
(→ Technical data)
The following restrictions apply to the unit:
• Only use indoors and for aquaristic purposes in the
home (not for commercial use).
• Only operate with water at a water temperature of
+4 °C to +35 °C.
Function description
 C
Drawn in by a pump into the pump unit, the water
flows through two filter chambers arranged one
behind the other. The first filter chamber is filled with
ceramic substrate, the second filter chamber contains
a 20ppi foam filter.
Quantity
1
1
1
1
1
1
1
2
1
1
1
Quantity
5
5
2
1
4
1
1
1
with instructions.

ACCESSING THE UNIT

Dismantling the unit head
How to proceed:
 D
1. Slide the closure on each side to the "padlock
open" symbol.
2. Lift the unit head from the container.
Fitting the unit head
How to proceed:
 E
1. Check that the seal on the unit head is correctly
positioned.
– Clean the seal, replace it if damaged.
2. Ensure that the vent hose is in place and is pointing
upwards.
3. Fit the unit head onto the container.
4. Slide the closure on each side to the "padlock
closed" symbol.

INSTALLATION AND CONNECTION

 F, G
The unit can be installed next to the aquarium or
fastened to the outside of the aquarium with the aid
of a holder (45051, not included in the delivery
scope). Note the maximum water height above the
filter. (→ Technical data)
Order of tasks to be carried out:
1. If the unit is to be installed in a standing position:
Fit the enclosed rubber feet onto the base of the
container.
2. Position the filter media (→ Cleaning/replacing the
filter media)
3. Establish the connections (→ Establishing the
connections)
- EN -
15