METHVEN Breeze BRBSMCPUK Installation Manual

METHVEN Breeze BRBSMCPUK Installation Manual

Bath and shower mixer

Advertisement

Quick Links

Step 5

Remove the cover from the handset mounting
bracket.
Position the handset mounting bracket where
required and secure in place using the screws.
Ensure a waterproof seal is achieved between the
bracket and mounting surface.
Refit the cover onto the handset mounting
bracket.
Note: When selecting the position of the
handset mounting bracket, ensure that shower
hose is not stretched or subjected to tight
bends.

Care and Cleaning:

Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly with
contamination free warm soapy water and a damp soft cloth.
Methven warrants this product against manufacturing defects and that it is suitable for use
under the general operating conditions specified in this instruction sheet. However, regional
regulations apply and may affect your warranty. Please refer to www.methven.com or call
customer service for full details.
New Zealand
0800 804 222
439863
Australia
1300 638 483
BATH AND SHOWER MIXER
Installation Guide
Technical Specifications:
Operating Pressure:
Min: 50kPa/0.5bar
Max: 1000kPa/10bar*
Optimum: 150kPa/1.5bar - 500kPa/5bar
Operating Temperature:
Hot: Max 70°C*
Cold: Min 5°C
Inlet Connections:
All ¾" BSP
* Regional specific regulations apply.
Please refer to your warranty statement at
www.methven.com
UK
0800 195 1602
ISSUE A
www.methven.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Breeze BRBSMCPUK and is the answer not in the manual?

Questions and answers

Summary of Contents for METHVEN Breeze BRBSMCPUK

  • Page 1 Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly with contamination free warm soapy water and a damp soft cloth. Methven warrants this product against manufacturing defects and that it is suitable for use under the general operating conditions specified in this instruction sheet. However, regional regulations apply and may affect your warranty.
  • Page 2 IMPORTANT: Before you begin, turn off the water supply. General: Step 1 • Methven recommends this product is installed by a licensed plumber in compliance with all relevant regional regulations. • Insert base ring seals into the grooves in the bottom of the base rings.

Table of Contents